Mattel HOT WHEELS Power Tower Track Set User manual

Click!
Click!
Click!

8
4
7
6
5
+
+
-
-
Switch ON.
Let's Play!
Reattaching & Removal
30 cm
12"
Connect Create your own set-ups with other Wall Tracks™ sets.
Load car and launch!
Send your cars
in different directions!
Hang Track on Wall
1. Once poster and brackets are mounted on wall, attach tower as shown.
2. Attach remaining track pieces as shown.
FOR INSTRUCTIONAL VIDEOS
AND MORE GO TO
www.Hotwheels.com/wall-tracks
FOR INSTRUCTIONAL VIDEOS
AND MORE GO TO
www.Hotwheels.com/wall-tracks
Mounting brackets are designed to
break away from the set without
causing surface damage. If mounting
plate separates from bracket, snap
bracket back into place.
To remove brackets from the wall entirely:
1. NEVER pull strip towards you.
2. Hold bracket gently to prevent it from
snapping fingers. DO NOT press against wall.
3. Grab tab on Command™ Strip and SLOWLY
STRETCH STRAIGHT DOWN ALONG WALL AT
LEAST 12 INCHES until bracket and strip
release.
Purchase medium Command™ Refill Strips to
reapply to your wall.
SEE OTHER SIDE FOR STEPS 1-3
Hang Brackets
Battery Installation
• Unscrew the battery cover with a Phillips head
screwdriver (not included).
• Install 2 "D" size (LR20) alkaline batteries (not
included) in the orientation (+/-) shown.
• Replace battery cover and tighten screw.
• For longer life use alkaline batteries.
• Replace batteries when vehicles can no longer
reach the top of the tower.
• When exposed to an electrostatic source, the
product may malfunction. To resume normal
operation, remove and re-install the batteries.
NOTE: For optimal adhesion performance
3M recommends waiting 1 hour before
adding weight to Command™ Strips.
Red arrow should line up
with arrow on bracket.
CORRECTCORRECT INCORRECTINCORRECT
Remove black-printed liner
from Command™ Strips and
attach each bracket into the
designated notch of the poster
as shown.
Bracket should not overlap the
poster.
PRESS FIRMLY
FOR 30 SECONDS
PRESS FIRMLY
FOR 30 SECONDS
Press bracket firmly onto
wall and hold, pressing for
30 seconds.
IMPORTANT NOTE: Elevator will not function if
Part B is not properly connected as shown in
ASSEMBLE TRACK PIECES steps 1 and 2.
b
a
10.75”10.75”
12.5”
12.5”
b
I
o
a
I=ON
O=OFF