−6−
6. MAGAZINE ASSY. (3)
1. Place the circuit board part of the Staple Switch Assy. in the center of the lower part of the
Magazine Assy. in the direction as shown in the diagram, and fix to the Magazine Assy. using the
Tap Tight (P) 2x4 CF. Insert the wires coming from the circuit board into the Hook on the Magazine
Assy. as shown in the diagram.
2. Hook one end of the Spring 3269 on to the hook of the Feed Plate. Insert the Feed Plate in the
direction shown in the diagram from the entrance in the rear part of the Magazine until it has been
completely inserted, and then hook the other end of the Spring 3269 onto the hook on the Magazine
according to the diagram.
After mounting the Spring, confirm that the hook parts have not changed shape.
3. Matching the tip of the Short hook of the Feed Lever (see diagram) to the hole of the Feed Plate,
insert the round projections on both sides of the Feed Lever into the corresponding holes in the rear
part of the Magazine Assy.
4. Holding the Staple Switch Plate inserted in the Actuator, mount the assembly in the Magazine Assy.
so that it is located on top of the circuit board of the Staple Switch Harness Unit that was previously
installed in the Magazine Assy.
5. Hook the ends of the two Springs 3248 onto the grooves at both ends of the Cartridge Holding
Shaft. Mount the Cartridge Holding Shaft in the U-shaped depressions at the rear of the Magazine
Assy., and hook the other ends of the Springs 3248 on to the protuberances on the Magazine as
shown in the diagram. (In 2 places, at left and right.)
ASSEMBLY PROCEDURE
Hook the wires on to the Hook
on the Magazine Assy. base.
Take care not to break the
covering of the harness wires.
SPRING 3269
(KK13269)
Short Hook
Long Hook
FEED PLATE (EH12693)
Do not apply oil to this part. If oil becomes
attached, remove by wiping with alcohol.
MAGAZINE ASSY. (2)
SPRING 3248
(KK13248)
STAPLE SWITCH PLATE
(EH12689)
STAPLE SWITCH ASSY.
(EH70497)
FEED LEVER (EH12292)
CARTRIDGE HOLDING SHAFT
(EH12687)
TAP TIGHT (P) 2x4 CF
(AA05553)
Take care of the mounting direction
Tightening torque: 0.20N·m
(2kgf·cm)