Mercedes-Benz B67876131 User manual

• Accessories
Installation Instructions
Mercedes-Benz Cradle adaptor with
Bluetooth®wireless technology
5. Entwurf GEN II
01.06.2006 / 03F037-06

Mercedes-Benz Cradle adaptor
with Bluetooth®wireless
technology
1
M+P-03F-6662

- 1 -
The Mercedes-Benz approved/
recommended Bluetooth®Phones can be
utilized inside Mercedes-Benz vehicles.
Application
These installation instructions are valid for
vehicles with an MHI hands-free
communications systems and a
Mercedes-Benz-approved Bluetooth®
mobile telephone. Approved mobile
telephones are listed and can be purchased
on the Internet at www.wireless4mb.com or
call 1-800-266-7746 to speak to a wireless
activation specialist.
Parts included
• (1) Mercedes-Benz Cradle adaptor
with Bluetooth®wireless
technology
Notes
Please contact your local Mercedes-Benz
Center if you encounter difficulties when
operating the Mercedes-Benz Hands-Free
Communication System.
More information can be found on the
Internet at www.wireless4mb.com or call
1-800-266-7746 to speak to a wireless
activation specialist.
GWarning
It is not recommended to operate
the mobile telephone keypad while
driving.

- 2 -
Notes
The manufacturer reserves the right to
change technical details from those shown
in the illustrations contained in these
installation instructions.
These installation instructions also refer to
the vehicle Operator's Manual, COMAND
Operator's Manual, and mobile telephone
manual. Please refer to them for reference.
Use of a mobile telephone other than a
Mercedes-Benz approved/recommended
model may result in improper performance
and cannot be equipped or serviced by
Mercedes-Benz.
Installing the Mercedes-Benz Cradle
adaptor with Bluetooth®
Insert the Mercedes-Benz Cradle adaptor
with Bluetooth®(1) into the latches on the
pre-installed contact plate (2), located in the
center console. To insert the Mercedes-Benz
Cradle adaptor with Bluetooth®(1), slide it
upwards until it clicks into place.
2
1
M+P-03F-6663

- 3 -
Pairing the mobile telephone with the
Mercedes-Benz Cradle adaptor with
Bluetooth®
Make sure that the starter switch is in
position 1, 2 or 3 (see the vehicle Operator's
Manual).
1. With Mercedes-Benz Cradle adaptor
with Bluetooth®connected to the vehicle
press button (3) for approx. 2-3 seconds.
The LED (4) will begin to flash rapidly. The
Mercedes-Benz Cradle adaptor with Blue-
tooth®is in Discovery Mode and can be
detected by a Bluetooth®mobile telephone.
The Mercedes-Benz Cradle adaptor with
Bluetooth®will appear as "MB
PhoneSystem" on the mobile telephone.
4
3
M+P-03F-6664

- 4 -
2. For instructions on how to get the
mobile telephone ready for pairing, see the
mobile telephone manual or visit
www.wireless4mb.com. Once the mobile
telephone and Mercedes-Benz Cradle
adaptor with Bluetooth®find each other the
mobile telephone will prompt the user to
enter a Pass-Key.
Note
Located on the backside of the
Mercedes-Benz Cradle adaptor with
Bluetooth®there will be a sticker containing
the Pass-Key (5).
4. When prompted, enter the Pass-Key
into the mobile telephone. Depending on the
type of mobile telephone being used, it may
be necessary to confirm a connection
request (see the mobile telephone manual).
5. Once the Pass-Key has been entered
and accepted the LED (4) will be lit
continuously. This confirms that the mobile
telephone is paired and connected and the
mobile telephone information has been
stored in the Mercedes-Benz Cradle adaptor
with Bluetooth®.
6. The mobile telephone is now ready for
use with the Mercedes-Benz Hands-Free
Communication System.

- 5 -
Establishing a Bluetooth® Connection
Notes
A maximum of 4 mobile telephones can be
paired with the Mercedes-Benz Cradle
adaptor with Bluetooth®. However, only one
mobile telephone is connected to the
Mercedes-Benz Cradle adaptor with
Bluetooth®at a time. If a fifth mobile
telephone is paired with the Mercedes-Benz
Cradle adaptor with Bluetooth®, then the
information stored from the first mobile
telephone which was paired with the
Mercedes-Benz Cradle adaptor with
Bluetooth®will be replaced.
When the starter switch is in position 1, 2 or
3 (see the vehicle Operator's Manual), the
Mercedes-Benz Cradle adaptor with
Bluetooth®will search for the last
connected mobile telephone and reconnect.
The Mercedes-Benz Cradle adaptor with
Bluetooth®will search continiously and
automatically after startup for one of the
paired phones.
If the last connected mobile telephone is not
found the Mercedes-Benz Cradle adaptor
with Bluetooth®will search for one of the
previously paired phones and connect to it.
The searching routine is being repeated as
long as a paired mobile phone is ready to be
connected. Searching is indicated with
LED (4) flashing periodically.
If the connection between the
Mercedes-Benz Cradle adaptor with
Bluetooth®and mobile telephone is not
established automatically, it is possible to
establish a connection manually (see
page 7).

- 6 -
When using Bluetooth®the mobile
telephone uses more power. Since the
mobile telephone is not being charged the
battery should have a sufficient charge.
SMS messages can not be accessed via the
COMAND or radio while the Bluetooth®
connection is established.
Not every ring-tone of the mobile telephone
is supported by the COMAND or radio.
3-way-calling and call waiting are not
supported from the Mercedes-Benz Cradle
adaptor with Bluetooth®. An audible peep
will notify a waiting call.
The roaming indication is not supported by
the COMAND or radio.
For a list of supported features please visit
www.wireless4mb.com.
The Tele Aid System (emergency call
system) will continue to function as
designed as long as there is a valid service
contract.

- 7 -
Connecting the mobile telephone and
Mercedes-Benz Cradle adaptor with
Bluetooth®manually
Valid for all Mercedes-Benz vehicles with the
exception of the model year 2007 S-Class:
• Press button on the COMAND or
radio.
Model year 2007 S-Class vehicles:
• Using the COMAND Controller, select
"Telephone" 씮"Telephone" 씮
"Telephone on".
Note
Before manual connection, the mobile
telephone must previously be paired with
the Mercedes-Benz Cradle adaptor with
Bluetooth®(see pairing procedure on
page 3).
The Mercedes-Benz Cradle adaptor with
Bluetooth®will search continuosly and in
sequence for one of the paired mobile
phones. If a bluetooth connection is
disconnect manually that adapter will stop
searching.
When the mobile telephone is within the
range (approx. 30 ft) of the Mercedes-Benz
Cradle adaptor with Bluetooth®, the
connection between the mobile telephone
and the Mercedes-Benz Cradle adaptor with
Bluetooth®remains active, and phone calls
made with the mobile telephone use the
vehicle’s hands-free system. For this reason,
the connection between the mobile
telephone and the Mercedes-Benz Cradle
adaptor with Bluetooth®should be
disconnected manually if the mobile
telephone is taken out of the vehicle (see
page 8).

- 8 -
Disconnecting the Bluetooth®
connection automatically
The connection between the Mercedes-Benz
Cradle adaptor with Bluetooth®and the
mobile telephone is automatically
disconnected when the mobile telephone
travels outside of the range (approx. 30 ft) of
the Mercedes-Benz Cradle adaptor with
Bluetooth®.
Disconnecting the Bluetooth®-
connection manually
The connection between the mobile
telephone and the Mercedes-Benz Cradle
adaptor with Bluetooth®can be
disconnected at any time by using the
mobile telephone (see the mobile telephone
manual).
To disconnect the paired mobile telephone
from Mercedes-Benz Cradle adaptor with
Bluetooth®using the COMAND or radio.
Valid for all Mercedes-Benz vehicles with the
exception of the model year 2007 S-Class:
• Press and hold button on the
COMAND or radio for approx.
3 seconds.
Model year 2007 S-Class vehicles:
• Using the COMAND Controller, select
"Telephone" 씮"Telephone" 씮
"Telephone off".
Note
If a phone call is in progress, the connection
can only be disconnected directly on the
mobile telephone (see the mobile telephone
manual).