Mercedes-Benz MVI250 User manual

Mercedes-Benz
Parking Assistant System
Easy Operation Manual
Model: MVI250(A/B/C/E/S/CLS/V-Class)
For ALL NTG5/5.1 system

Installation (For W205/222/447)
1. The center armrest silver cover should be
removed by using a pry tool.
2. Remove two screws then whole
panel can be removed
3. Remove the trim in upward motion, be careful
with the marked hooks.
4. Remove two screws on the top of
comand, then the radio unit

Installation (For W246/176/117/W156)
1. Use tool pry tool to remove Left
and Right Air - conditioning vents
2. Remove parts
3. Remove screws(Left and Right) then you can remove Audio system

Installation
5. Remove the 12 pin plug with
can bus and aux cables form
the quadlock plug and integrate
camera kit cable between
multimedia unit and removed 12
pin plug
Remove original blue LVDS monitor
plug, plug it into camera module LVDS-
out connector, and connect the supplied
LVDS cable from display port to LVDS
input port in the camera module
6. Connect the power cable to the
fuse box and grounf cable to
chassis
7. install module and camera and
check if everything works before
assembling the parts back
GND
Power 12V

Products
This section describes the company's products
Thank you for using our products, after you get the product, please carefully check the open standard
accessories listed below are included
1.1. Accessory list
Sequence No.
N. ame
Picture
Amount
1
Camera
interface
1
2
Quadlock cable
adapter
1
3
LVDS video cable
1
!
!
!
!
!
!
!
!

power
TO
Control
Box
Original LCD cable
Offered LCD cable
Monitor
2 . Mercedes-Benz Parking Assistant System Easy Guide
2.1. Steering wheel buttons Operating Instructions
Start
the car, the system will automatically power on.
P
ress the red circle around the position of the steering wheel "Mute" or "Return" buttons few seconds to turn on
video input mode (this is usually used for front camera activation), to exit press the butto
n again for few seconds
!
!
!
If your Mercedes-Benz car without parking sensor or with Manual transmission, it will not auto change to
camera video, you must:
1. Turn Dip 8 UP on
2. Blue wire connection to back light(12V)
Note: Customers can function DIP switch status to select according to their actual needs.
!
!
!
!
!