Merit Megatouch Money Shoot User manual

COPYRIGHT©2005MERITINDUSTRIES,INC.
HardDriveRemoval
1. Turn off and unplug the game.
2. Unlock and open the bottom door.
3. Remove the 4 screws fastening the electronics box cover and carefully remove the cover.
See Figure 1.
4. Using Figure 2, locate the hard drive behind the I/O board. Remove the 4 screws and any
connectors securing the I/O board to the hard drive assembly.
5. Remove the 5 shoulder washers securing the hard drive assembly to the electronics box, then
remove the assembly until you’re able to disconnect the hard drive power connector and hard
drive ribbon cable. See Figure 2.
6. Remove the 4 screws fastening the hard drive to the mounting plate. See Figure 3.
7. Slide the hard drive out of the mounting plate.
HardDriveInstallation
1. Slide the new hard drive into the mounting plate and secure with the 4 screws.
2. Using the existing hardware, re-secure the I/O board to the hard drive mounting plate. Recon-
nect any necessary connectors.
3. Reconnect the power connector and ribbon cable to the hard drive, then slide the hard drive
assembly into place in the electronics box. Tighten the 5 shoulder washers to secure. See
Figure2.
4. Replace the electronics box cover and fasten it with the 4 screws. See Figure 1.
5. Close and lock the bottom door.
6. Plug in and turn on the game.
ATTENTION:
OBSERVEPRECAUTIONSFORHANDLINGELECTROSTATICDEVICES
Removal/Installation of Major Assemblies -
Megatouch Money Shoot

COPYRIGHT©2005MERITINDUSTRIES,INC.
FIGURE1- CLOSED ELECTRONICSBOX-LOCATED INBOTTOMOFMONEYSHOOTCABINET
FIGURE2-ELECTRONICS BOXWITHCOVERREMOVED -CPUSECTION
4 SCREWS TO REMOVE
ELECTRONICS BOX COVER
SHOULDER WASHERS
SECURING HARD DRIVE
A
SSEMBLY (5 TOTAL – 2 ON
ELECTRONICS BOX FLOOR)
HARD DRIVE
I/O BOARD
FIGURE3- HARDDRIVE
POWER
CONNECTOR
RIBBON
CABLE
SCREWS FASTENING
HARD DRIVE TO
MOUNTING PLATE
(4 PLACES)