Metra Electronics 95-7427B User manual

INSTALLATION INSTRUCTIONS FOR PART 95-7427
95-7427B/
95-7427G
APPLICATIONS
Nissan Maxima 2009-11
/o Navigation or Technology Package
KIT FEATU ES
• Double DIN adio Provision
• Stacked ISO Mount Units Provision
• PAINTED TO MATCH FACTO Y DASH:
95-7427B=BLACK, 95-7427G=G AY
• Textured To Match Factory Dash
• A) Double DIN adio Housing
KIT COMPONENTS
TOOLS EQUI ED:
Small Flat Blade Screwdriver/ Panel emoval Tool
• Phillips Screwdriver
1-800-221-0932
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
A

Dash Disassembly
- Nissan Maxima 2009-11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Kit Assembly
- Double DIN Radio Provision / Stacked ISO Mount Units Provision . . . .2
Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
TABLE OF CONTENTS
95-7427
*Note:
Refer also to the instructions included with the aftermarket radio.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.

95-7427 DASH DISASSEMBLY
NISSAN MAXIMA 2009-11
A
X
OFF
PASS
AIR
BAG
CD CHANGER
AUX IN
B
C
D
1
1
Unclip and remove the panel below
the radio. ( Figure B)
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
3
Unclip and remove the panel above
the radio including the a/c vents and
the climate controls. Unplug and
remove the panel. (
Figure A)
2
emove (6) Phillips screws securing
the radio. Unplug and remove the
radio. (
Figure C)
4
emove (5) Torx head screws secur-
ing each side bracket to factory radio
and remove brackets and module.
( etain brackets, module and (2)
screws from module for re-use during
kit assembly.) (
Figure D)
5
Continued on page 2.

95-7427 KIT ASSEMBLY
2
DOUBLE DIN RADIO PRO ISION OR
STACKED ISO MOUNT UNIT(S) PRO ISION
Attach the factory brackets and mod-
ule to the Double DIN or stacked ISO
mount unit(s) with the screws supplied
with the unit(s) and (2) screws from
1
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
A

95-7427 FINAL ASSEMBLY
FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends to ether
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the proper mating
adapter and making the connections as shown. (Isolate and individually tape off the ends of
any unused wires to prevent electrical short circuit).
e-connect the negative battery terminal and test the unit for proper operation.
Position the factory bracket/aftermarket radio assembly into the dash and secure using
the factory hardware.
1
2
3
Secure the Double DIN radio housing to the sub dash using the factory hardware.
4
eassemble the rest of the dash in reverse order of disassembly.
Make wiring connections using the EIA color code chart shown below and the instructions
included with the head unit. Metra recommends making connections shown below; Strip, Splice,
Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short
5
3
METRA / EIA WIRING CODE
12V Ign t on / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / Wh te
Amp Ground. . . . . . . . . . . . . . Black / Wh te
Illum nat on . . . . . . . . . . . . . . Orange
D mmer . . . . . . . . . . . . . . . . . Orange / Wh te
R ght Front (+) . . . . . . . . . . . . Gray
R ght Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . Wh te
Left Front (-). . . . . . . . . . . . . . Wh te / Black
R ght Rear (+) . . . . . . . . . . . . V olet
R ght Rear (-) . . . . . . . . . . . . . V olet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis. All colors may not be
present on all leads due to manufacturer’s specifications.

NOTES
4
95-7427

NOTES
5
95-7427

95-7427 INSTRUCTIONS
1-800-221-0932
REV. 10-06-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST95-7427
www.metraonline.com