Metra Electronics 95-8208 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-8208
APPLICATIONS
Toyota Sienna
2004-2010
KIT FEATURES
•Double DIN Radio Provision
•Stacked ISO Mount Units Provision
•A) Radio Housing • B) Double Din Trim Plate • C) Double DIN Brackets
KIT COMPONENTS
A
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
•Socket Set
1-800-221-0932
©COPYRIGHT 2007-2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
B
95-8208
C
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• 70-1761 -Toyota harness 1987-up
•TYTO-01 - Toyota amp harness 2003-up
Antenna Adapter:
•Not required

Dash Disassembly
- Toyota Sienna 2004-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Kit Assembly
-Double DIN Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
-Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Final Assembly ........................................... 4
TABLE OF CONTENTS
95-8208
*Note:
Refer also to the instructions included with the aftermarket radio.

95-8208 DASH DISASSEMBLY
Toyota Sienna 2004-2010
A
B
C
1
1
Unclip and remove panels from left
and right side of radio. ( Figure A)
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
2
Unclip and remove panel or speaker
cover above radio. (Figure B)
3
Remove (4) 10 MM bolts securing the
radio. Unplug and remove the radio.
(Figure C)
4
Continue to final assembly.

95-8208 KIT ASSEMBLY
2
B
A
C
DOUBLE DIN RADIO PROVISION
Slide the Double DIN radio into the
bracket/housing assembly and secure
the radio to the assembly using the
screws supplied with the radio.
(Figure B)
2
Snap the Double DIN brackets to the
inside edge of the radio housing.
(Figure A)
1
Snap the Double DIN Trim plate into
the Radio Housing.
(Figure C)
3
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.

95-8208 KIT ASSEMBLY
3
B
A
C
STACKED ISO UNITS PROVISION
Slide the stacked ISO units into the
bracket/housing assembly and secure
the units to the assembly using the
screws supplied with the units.
(Figure B)
2
Snap the Double DIN Trim plate into
the Radio Housing.
(Figure C)
3
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Snap the Double DIN brackets to the
inside edge of the radio housing.
(Figure A)
1