Metra Electronics 99-3305 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-3305
99-3305
KIT FEATURES
•DIN Radio Provision with Pocket
•ISO Radio Provision with Pocket
•A) Radio Housing • B) ISO Brackets • C) Trim Plate
KIT COMPONENTS
A
Small Flat Blade Screwdriver • Panel Removal Tool
•Phillips Screwdriver • Socket Set • Torx Driver • Allen Wrench
1-800-221-0932
©COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION
www.metraonline.com
TOOLS REQUIRED:
APPLICATIONS
CHEVROLET
Avalanche 2007-09/Equinox 2007-09
Express Van 2008-09/Impala 2006-09
Monte Carlo 2006-07/Tahoe 2007-09
Silverado 2007-09
(Excluding Classic Models)
Suburban 2007-09
BC
BUICK Enclave 2008-09, Lucerne 2006-09
GMC Acadia 2008-09
Savanna 2008-09
Sierra 2007-09
(Excluding Classic Models)
Yukon 2007-09
SATURN Outlook 2008-09/Vue 2008-09
SUZUKI XL7 2007-09
HUMMER H2 2008-09
PONTIACTorrent 2007-08
WIRING AND ANTENNA CONNECTIONS:
(Sold Separately)
Harness:
•GMOS-LAN-01 - GM LAN interface 2006-up
•GMOS-LAN-02 - GM LAN amplified interface 2006-up
Antenna Adapter:
•40-CR10 - Chrysler/GM antenna adapter 2002-up

TABLE OF CONTENTS
99-3305
*Note:
Refer also to the instructions included with the aftermarket radio.
D ash Disassembly
-ChevroletImpala2006-2009. ................................................1
-ChevroletMonteCarlo2006-2007 .......... ..................................1
-BuickLucerne2006-2009................................................... 1
-ChevroletAvalanche2007-2009 ..............................................2
-Chevrolet Silverado (Excluding Classic Models) 2007-2009 .....................2
-ChevroletSuburban2007-2009 ...............................................2
-ChevroletTahoe2007-2009...................................................2
-GMC Sierra (Excluding Classic Models) 2007-2009 . ...........................2
-GMC Yukon 2007-2009 . . .....................................................2
-Chevrolet Express Van 2008-09/GMC Savanna2008-2009 ........................3
-Suzuki XL-7 2007-2009 .....................................................4
-Chevrolet Equinox 2007-089/Pontiac Torrent 2007-2008 . . . . . . . . . . . . . . . . . . . . . . . . . . 5
-Buick Enclave/ GMC Acadia/ /Saturn Outlook 2008 . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . 6
-HummerH22008-2009......................................................7
-SaturnVue2008-2009........................................................8
Kit Assembly
-DINRadioProvisionwithPocket .............................................9
-ISORadioProvisionwithPocket..............................................9
Final Assembly ....................................................10
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skillsby
enrolling in the most recognizedandrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.comor call
800-354-6782 for more informationandtake
steps towardabetter tomorrow.

99-3305 DASH DISASSEMBLY
BUICK LUCERNE
CHEVY IMPALA / MONTE CARLO 2006-09
A
B
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove the trim panel
around radio and a/c control.
(Figure A)
2
Remove (6) 9/32” screws to extract
radio and a/c control from sub dash.
(Figure B)
3
Continue to kit assembly.

2
99-3305 DASH DISASSEMBLY
A
B
C
SILVERADO (Excluding Classic Models) /SUBURBAN
CHEVY AVALANCHE/TAHOE
GMC YUKON/SIERRA (Excluding Classic Models) 2007-09
Unclip and remove radio trim panel.
(Figure A)
2
Remove (2) 8mm screws securing
switch panel below climate controls.
Unplug and remove switch panel.
(Figure B)
3
Remove (2) 8mm screws securing cli-
mate controls. Unplug and remove cli-
mate controls.
(Figure B)
4
Remove (4) 9/32” screws securing
radio. Unplug and remove the radio.
(Figure C)
5
Continue to kit assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Disconnect the negative battery termi-
nal to prevent an accidental short cir-
cuit.
1

3
99-3305 DASH DISASSEMBLY
CHEVY EXPRESS VAN 2008-09/GMC SAVANNA 2008-09
Remove (2)10mm bolts from below knee bolster under steering column and remove
panel.
2
Remove (2)10mm bolts from panel below passenger dash airbag and remove panel. 3
Unsnap and remove radio and instrument cluster panel. (May not be necessary to
completely remove radio and instrument cluster panel to access radio.)
4
Remove (4) 9/32” bolts to remove radio. 5
Continue to kit assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Disconnect the negative battery terminal to prevent an accidental short circuit. 1

4
99-3305 DASH DISASSEMBLY
A
B
C
D
E
SUZUKI XL-7 2007-09
Press in on sides of the shifter boot to
release it from the shifter trim panel.
(Figure A)
2
Lift the boot up to access the Allen
screw securing the shifter knob to the
shifter lever. Loosen the Allen screw
and remove the shifter knob.
(Figure B)
3
Remove (1) torx screw from the shifter
trim panel
(Figure C) , then using a
panel removal tool unsnap the shifter
trim panel. Unplug and remove the
panel.
(Figure D)
4
Remove (4) 9/32” screws securing
the radio. Unplug and remove the
radio.
6
Using a panel removal tool unsnap
the radio trim panel. Unplug and
remove the panel.
(Figure E)
5
Continue to kit assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Disconnect the negative battery termi-
nal to prevent an accidental short cir-
cuit.
1

5
99-3305 DASH DISASSEMBLY
A
B
C
CHEVROLET EQUINOX2007-09
PONTIACTORRENT 2007-09
Unsnap panel below power window
switchand remove. Note: This allows
you to unplug the window switch easi-
er. (Figure A)
3
Unsnap and remove entirepanel sur-
rounding radio and shifter.
(Figure B)
4
Remove shifter knob. 2
Remove (4) 9/32 screws securing
radio.Unplug and remove the radio.
(Figure C)
5
Continue to kit assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Disconnect the negative battery termi-
nal to prevent an accidental short
circuit.
1

6
99-3305 DASH DISASSEMBLY
BUICK ENCLAVE
GMC ACADIA
SATURN OUTLOOK
BUICK ENCLAVE/GMC ACADIA/
SATURN OUTLOOK 2008-09
Unclip the radio trim panel including
the climate controls. Unplug the cli-
mate controls and remove the panel.
(See drawings)
2
Remove (4) 9/32 screws securing the
radio. Unplug and remove the radio.
3
Continue to kit assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Disconnect the negative battery termi-
nal to prevent an accidental short cir-
cuit.
1

7
99-3305 DASH DISASSEMBLY
A
HUMMER H2 2008-09
Unclip the radio trim panel including
the a/c vents. Unplug any harnesses
connected to the panel and remove the
panel.
(Figure A)
2
Remove (4) 9/32” screws securing the
climate controls. Unplug and remove
the climate controls.
3
Remove (4) 9/32 screws securing the
radio. Unplug and remove the radio.
4
Continue to kit assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Disconnect the negative battery termi-
nal to prevent an accidental short cir-
cuit.
1

8
99-3305 DASH DISASSEMBLY
A
B
C
SATURN VUE 2008-09
Unclip and remove the trim panel on
top of the radio trim panel.
(Figure A)
2
Remove (2) Phillips screws exposed
under panel removed in step 2.
(Figure B)
3
Unclip and remove the radio trim panel
including the a/c vents.
(Figure B)
4
Remove (4) 9/32 screws securing the
radio. Unplug and remove the radio.
6
Unclip and remove the trim panel
surrounding the shifter including the
climate controls. (Figure C)
5
Continue to kit assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Disconnect the negative battery termi-
nal to prevent an accidental short cir-
cuit.
1

99-3305 KIT ASSEMBLY
B
C
C
DIN RADIO PROVISION
ISO RADIO PROVISION
Slide the aftermarket radio into the
cage and secure.
(Figure C)
2
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down. (Figure B)
1
Slide the radio into the radio opening
until the side clips engage. ) (Figure C)
2
Snap the Trim plate into the Radio
Housing. (Figure C)
3
Mount the ISO Brackets to the radio
with the screws supplied with the
unit.
(Figure B)
1
NOTE: XL-7 ONLY
Trim top corners of radio housing.
(Figure A)
B
A
NOTE: XL-7 ONLY
Trim top corners of radio housing.
(Figure A)
A
9

99-3305 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
1
2
3
10
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc..........Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
REV. 05/27/09 © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION INST99-3305