Metra Electronics 99-9009 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-9009
86-9001 Radio Removal Tools (2 sets) • Flat Blade Screwdriver
1-800-221-0932 www.metraonline.com
KIT FEATURES
©COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
•DIN Head Unit Provision with Pocket
•ISO DIN Head Unit Provision with Pocket
A) Radio Housing • B) ISO Snap-In Brackets • C) Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
99-9009
A
APPLICATIONS
VW Touareg/Touareg2
2004-2010
B
C
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
•70- 9003 - VW Toureg Harness 2004-up
Antenna Adapter:
•40-EU55 Amplified VW Antenna Adapter

99-9009
Dash Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Kit Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3
Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
TABLE OF CONTENTS
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skillsby
enrolling in the most recognizedandrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.comor call
800-354-6782 for more informationandtake steps
toward abetter tomorrow.

99-9009
1
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Insert the long ends of the 86-9001
into the slots on the factory radio
and pull out to remove.
(Figure A)
2
2004-2010 VW TOUAREG
NOTE:
Flat edge of key should point outward.
DASH DISASSEMBLY
A

99-9009
2
KIT ASSEMBLY
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down.
(Figure A)
1
A
Slide the aftermarket head unit into
the cage and secure. (Figure B)
2
DIN HEAD UNIT PROVISIONS
B

99-9009
3
KIT ASSEMBLY
Mount the ISO Brackets to the head
unit with the screws supplied with
the unit. (Figure A)
1
A
Slide the head unit into the radio
opening until the side clips engage.
(Figure B)
2
ISO DIN HEAD UNIT PROVISIONS
B
Snap the Trim plate into the Radio
Housing. (Figure B)
3

99-9009
4
FINAL ASSEMBLY
1
Locate the factorywiring harness in the
dash. Metra recommends using the
proper mating adapter and making the
connections as shown. (Isolate and indi-
vidually tape off the ends of any unused
wires to prevent electrical short circuit)
2
Re-connect the negative battery terminal
and test the unit for proper operation.
3
Reassemble radio and dash assemblies in
reverse order of disassembly.
A
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
B
C
D

99-9009
5
NOTES

INST99-9009
1-800-221-0932 www.metraonline.com
Rev.04-27-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-9009