Micropelt MLR003 User manual

Copyright Micropelt
MLRTPS Quickstart Guide
For inquiries please visit us at: Customer Service Portal
Email: [email protected]. Telephone [phone]

Copyright Micropelt
– 2
1. Gateway-Configuration
Load the device credentials DEVEUI, APPEUI (JOINEUI) and APPKEY supplied with the MLRTPS into your gateway.
Questions about device credentials can be sent directly to [email protected].
2. Installation
The MLRTPS is delivered with the battery disconnected.
1 MLRTPS Battery Disconnected
Mount the base plate on the wall, connect the battery on the MLRTPS and attach the housing onto the base plate.

Copyright Micropelt
– 3
1.
2.
3. Activation and operation
When the battery is first connected, the MLRTPS will immediately activate and send a Join Request to the gateway
(see picture).
2 MLRTPS Battery Connected
First acoustic signal (and 1x LED): confirms successful activation.
Double acoustic signal (and 2x LED): confirms successful connection join to the gateway.
Normal operation: For the first 5 minutes after activation the device will communicate every 10 seconds. Thereafter
the device communicates in a fixed radio communication interval (5 minutes).
Failure: Long acoustic signals indicate failed operations.
Remark join failure: Gateway or device credentials not configured Multitech MTCAP Gateway.
Repeat the process with 4. RESET

Copyright Micropelt
– 4
•
•
•
•
•
4. Device RESET
To perform the RESET, hold the magnetic pen on the “no change” / “default” marking on the product’s cover for
five seconds (tone signal and 1x LED). The MLRTPS restarts and attempts to join to the gateway
3 MLRTPS Device Reset
Additional things to know
LoRaWAN 868MHz CLASS A
Ambient Temperature sensor (± 0,5°C)
Passive Infrared Sensor - Detection Range approx. 10m
Set Point Values (-4° to +5° and Frost Protection)
Battery - Primary Cell 3.6V (2600mAh)
Tel: [phone]
E-Mail: [email protected]
Micropelt Homespace