Milwaukee PH55 User manual

BATTERY REPLACEMENT:
Units are supplied with BEPS (Battery Error Pre-venting
System) which avoids any erroneous reading due to low
battery level, by switching the meter off. To replace the
batteries unscrew the battery compartment cap and replace all
three 1.5V batteries while paying attention to their polarity.
Make sure the gasket is in place before screwing back the cap.
Batteries should only be replaced in a nonhazardous area using
the battery type specified in this instruction manual.
WARRANTY:
This meter (base unit) is warranted from all defects in
materials and manufacturing for a period of two years.
The electrode (probe end) is warranted for a period of 6
months.
During this period, the required repair or replacement of parts,
where the damage is not due to negligence or erroneous
operation by the user, will be effected free of charge.
WARRANTY REGISTRATION:
Please go to our web site and register your unit at
http://www.milwaukeeinstruments.com/registration.html
__________________________________________________
FOR A MUCH MORE DETAILED
OPERATORS MANUAL
GO TO OUR WEB SITE / MANUALS SECTION
AT THE FOLLOWING ADDRESS
www.milwaukeeinstruments.com
_______________________________________
Milwaukee Instruments
2950 Business Park Drive
Rocky Mount, NC 27804
Phone # [phone]
PH55 & PH56 WATERPROOF
METER
STARTER MANUAL

•When calibration is completed the unit LED will flash
“OK 2”for 2 sec. then return to the temperature display
& normal operation taking the unit out of the calibration
mode. ** YOU ARE NOW CALIBRATED AND
READY TO PERFORM MEASURMENTS
_____________________________________
#3: OPERATION OF THE PH55 –PH56:
• Remove the unit from your storage container cup or jar
( Remember to always store the probe wet )
• Turn the pH55 - Ph56 on by pressing the ON key.
• Immerse the electrode in the solution to be tested.
• Stir gently and wait for the reading to stabilize.
• After the reading is stable you can press “SET / HOLD”
button and unit will freeze display until you press the
“SET / HOLD” button again to release the display.
• After use, turn unit off by pressing the OFF key and
rinse the end of the probe with water and then return it
to jar or cup for storage.
____________________________________________
#3: STORAGE OF THE PH55 –PH56:
Leave the protective cap off and put the unit back in a
cup or jar that has 1” to 1.5” of either bottle drinking
water, or 4.01 calibration solution, or MA9015 storage
solution
___________________________________________
You Must Move Unit - VERY FAST –Between
The 7.0 & 4.0 Cal Solution During The
Calibration Procedure –> Please Read Through
Instructions prior to starting procedure
NEVER LET YOUR PROBE DRY OUT
_________________________________
NEVER USE DISTILLED OR
DEIONIZED WATER FOR STORAGE
PURPOSES.