Milwaukee SMS510 User manual

Milwaukee
USER MANUAL
PORTABLE
ORP METER
MODEL: SMS510
Smart Monitoring System
ISMIL510 12/01
Milwaukee
SPECIFICATIONS:
SMS510
RANGE ±1000 mV
RESOLUTION 1 mV
ACCURACY (@25°C) ±5 mV
SETPOINT 0 to 600 mV
ALARM active when the measure is
lower than setpoint
OUTPUT POWER SOCKET active when the measure is
lower than setpoint
ORP ELECTRODE MA921B/2 (included)
ENVIRONMENT 0 to 50°C, 95% RH max.
POWER SUPPLY 12 VDC (included)
POWER DRIVERS 115VAC, 2A, 60Hz or 230VAC, 1A, 50Hz
DIMENSIONS 160 x 80 x 40 mm
WEIGHT 220 g (meter only)
OPTIONAL ACCESSORIES:
MA921B/2 ORP Electrode with BNC connector and 2m cable
M10000B Electrode rinse solution, 20 mL sachet (25 pcs)
MA9015 Electrode storage solution, 220 mL bottle
MA950 Portable meter wall fixing kit
WARRANTY:
This instrument is warranted from all defects in materials and manufacturing for
a period of two years from the date of purchase.
The electrode is warranted for a period of 6 months.
If during this period, the repair or replacement of parts is required, where the
damage is not due to negligence or erroneous operation by the user, please return
the parts to either dealer or our office and the repair will be effected free of
charge.
Note: We reserve the right to modify the design, construction and appearance
of our products without advance notice.

OPERATION:
• Connect the supplied 12 VDC
power adapter to the meter
and to the mains.
• Connect the ORP electrode
to the BNC socket on the
bottom of the meter.
• Always remove the electrode
protective cap before taking
any measurement. If the elec-
trode has been left dry, soak
the tip (bottom 2.5 cm) in
rinse solution (M10000B) for
a few minutes to reactivate it.
• Turn the instrument on by
pressing the ON/OFF key.
• Allow the reading to stabilize
and the meter will start con-
tinuous monitoring.
• The meter is factory calibrated.
• A blinking alarm will indicate when the measured ORP
value is lower than the setpoint.
NOTE:
• The power contact is not protected by fuse inside the
meter. It is recommended to protect it outside, against
failure.
• WARNING: when the alarm led is blinking, the mains
voltage is present in the output power socket.
SETPOINT:
• The setpoint can be selected
by adjusting the central front
knob to the desired value.
• The selectable range for
SMS510 is from 0 to 600 mV.
INSTALLATION PROCEDURE: