Mitsubishi Electric Lossnay LGH-50 RVS User manual

PUBLISHED Oct 2023
www.mitsubishi-electric.co.nz | 0800 784 382
intervals in order to prevent a deterioration in the Lossnay functions.
Guideline:
are indicated on the
remote controller)
Clean the Lossnay cores if they are dirty.
should be increased depending on their dirtiness.)
WARNING
CAUTION
It could cause injury.
It could cause injury if parts fall.
Maintenance cover
Upper two screws are fastened
enough to remove the cover.
Lower two screws have fall
Maintenance cover
Use a vacuum cleaner to remove light dust. To remove stubborn
CAUTION
Maintenance cover for the other parts have also structure of
Maintenance cover
for the other parts
1. Pull out the upper part of the inner cover frontward and remove it
in the direction of the arrow in below picture.
it.
CAUTION
Inner cover
Cable clamp
Motor cable
Vacuum cleaner
Complete Filter replacement for standard filters is 2
years maintenance cycle
While for the High efficiency filter that are used on
OA section is every 1 year maintenance cycle
FILTER CLEANING LGH-50/80/100 RVS

www.mitsubishi-electric.co.nz | 0800 784 382www.mitsubishi-electric.co.nz | 0800 784 382
Hold the handle and draw the Lossnay cores out from the unit.
Lossnay cores.
CAUTION
Lossnay core
2. Put the Lossnay core in a suitable vessel (e. g. a small tub or the
shower tray) and rinse the Lossnay core with clear water from all
sides.
3. Carefully clean the air inlets and housing thoroughly with a broad
soft brush.
4. Rinse the Lossnay core from all sides thoroughly with clear water.
5. Lift the Lossnay core from the vessel and remove the remaining
water inside the Lossnay core by rotating the Lossnay core
repeatedly.
ventilation unit. Operate the unit at least one day for drying inside
the core.
CAUTION
Vacuum cleaner (with
brush attachment)
LOSSNAY CORE CLEANING

For more information please contact our Technical Support Team on 0800 737 842
1. Refer to 4.1 Removing the parts
Lossnay cores.
around the drain discharge holes with a soft cloth.
CAUTION
Drain pan
causes the drain discharge hole
clogging on both the air supply and
clean the drain pan.
Core rail part
1. Refer to 4.1 Removing the parts
Lossnay cores.
CAUTION
Drain pan
Cotton swab
that the cotton swab is able to pass through both
Drain catch basin
DRAIN SIPHON CLEANING