Mocka Octavia Coastal Cot User manual

Octavia Coastal Cot
1
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 18, Pinkenba, QLD 4008
Thank you for your purchase.
Please follow the instructions below for correct assembly.
Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters
and power points. Keep all medications, string, elastic, small toys or small items,
such as money, out of reach from any position in the cot.
Assembly
Care must be taken when attaching sides. Do not over-tighten screws as this can
cause damage to the cot.
Care and Maintenance
Regularly check all screws for tightness or damage that could render the cot
unsafe. To clean - use a damp cloth, avoiding the use of detergents or abrasives.
Recommended mattress size
This cot has been manufactured for use with a mattress which measures 1300mm
long x 690mm wide x 100mm in thickness. The width and length are specified
because it is important that gaps between the mattress and the sides and ends
of the cot will not exceed 40mm. This is to minimize the risk of a child’s limb
becoming caught in the gap. The thickness of the mattress has been specified to
ensure that the depth of the cot is greater than 500mm with the mattress base in
the lower position to minimize the risk of a child climbing or falling out of the cot.
E
A
x1
Allen key
x16
screw
B
x4
screw
WARNING: TO PREVENT FALLS, THE MATTRESS BASE
OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST
POSITION BEFORE THE CHILD CAN SIT UP
Side Panel
Cot Mattress Base End Panel
C D
x4
screw
x4
nut

mocka.co.nz | mocka.com.au | PO BOX 18, Pinkenba, QLD 4008
E
12
Octavia Coastal Cot
2
Assembly Instructions
A
A
A
A
A
A
A
AA
A
A
A
Attach panels [1] to panels [2] and secure with 8 x screws (A).
Tighten with an Allen Key (E).
E
A
Attach assembled panels together with panel [3] and secure with
4 x screws (A). Tighten with an Allen Key (E).
1
2
2
1
2
2
3

mocka.co.nz | mocka.com.au | PO BOX 18, Pinkenba, QLD 4008
A
A
3
3
Assembly Instructions
Octavia Coastal Cot
4
B
B
B
B
A
AA
A
4
3
Attach panel [4] to assembled frame as shown and secure with 4 x
screws (B). Attach 4x screws(C) to 4x nuts(D).
Tighten with an Allen Key (E).
Attach panel [3] to assembled frame as shown and secure with 4 x
screws (A). Tighten with an Allen Key (E).
E
C
D
C
D
C
D
C
D

mocka.co.nz | mocka.com.au | PO BOX 18, Pinkenba, QLD 4008
5
4
Assembly Instructions
Octavia Coastal Cot
OPTIONAL/MATTRESS HEIGHT ADJUSTMENT (please keep these
instructions handy for future reference)
To adjust mattress base settings, remove screws(C) and nuts (D).
Repeat steps 2, 3 and 4 by removing the side panel and moving the
base to corresponding holes. Securely attach again in the adjusted
position.
B
B
B
B
4