Mocka Original Highchair User manual

IMPORTANT!
KEEP FOR FUTURE REFERENCE:
WARNING: Never leave your child unattended in the highchair. Strict
adult supervision is required at all times.
WARNING: Ensure the safety strap is in use at all times to avoid the child
slipping downwards and causing injury. We recommend the use of the
shoulder and waist harness for added safety and to avoid injury caused
by falls – this is available for $19.95.
WARNING: Do not use the highchair unless components are correctly
fitted and adjusted.
WARNING: Ensure the highchair is positioned away from objects or
structures that can cause injury. Be aware of the risk of open fire and
other sources of strong heat, such as electric bar fires, gas fires etc, in
the vicinity of the highchair.
WARNING: Ensure both the seat and footrest are locked into position,
and cannot be moved by hand, before placing the child in the highchair.
Do not tighten all screws until all components have been assembled.
The highchair should not be used until the child can sit up unaided.
Do not use the highchair if any part is broken, torn or missing.
Includes instructions for Original Highchair,
Soho Highchair & Designer Highchair
Highchair Harness
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

12
Connect the rest of the harness to the anchor-straps
ehtpeeK.nwohssaselkcubhtobrehtegotgnippilcyb
harness and middle buckle loose and open for now.
Separate the anchor straps and loop around the high-chair
supports and under the backrest. Tie to high-chair frame
by passing each clip through the loop in the straps.
x2 x2
For Original Highchair & Soho Highchair
Highchair Harness
2
mocka.co.nz | mocka.com.au
Assembly Instructions

12
Connect the rest of the harness to the anchor-straps
ehtpeeK.nwohssaselkcubhtobrehtegotgnippilcyb
harness and middle buckle loose and open for now.
Separate the anchor straps and loop around the high-chair
supports and under the backrest. Tie to high-chair frame
by passing each clip through the loop in the straps.
x2 x2
For Original Highchair & Soho Highchair
34
Finally, adjust the straps to ensure a snug fit around child’s
shoulders and chest. To take the child out of the chair,
simply unclip the buckle and slip off harness.
All done! Enjoy!
A. Carefully sit child in the highchair and slip arm through harness.
B. Slip child’s second arm through the harness loop.
C. With the harness sitting over the shoulders, clip the front buckles
together as shown.
B
C
A
For Original Highchair & Soho Highchair
Highchair Harness
3
mocka.co.nz | mocka.com.au
Assembly Instructions

56
C. Carefully seat child in the highchair and slip arms and
shoulders through harness.
D. Clip the front buckles together as shown. Adjust straps
to ensure a snug fit around child’s shoulders and chest.
A. Attach the anchor straps to the harness. Place the
complete harness inside the seat of the highchair and push
the two ends down through the seat holes.
B. Pull the anchor straps tight underneath and tie a reef knot.
C
D
A
B
x2
For Designer Highchair
Highchair Harness
Assembly Instructions
4
mocka.co.nz | mocka.com.au