Modular Closets Vista Drawer Kit Instruction manual

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
DRAWER KITS
1-844-969-4247 suppor[email protected]

1
1.1
1.2
Lay parts out on a protective surface to prevent damage. Tip: Spread out the cardboard packaging to
use as a protective surface.
Inventory parts against the Parts List. Make sure all parts are present before proceeding.
AB
C E
DF G H I
Drill, 5/32" bit size
Phillips Screwdriver
TOOLS REQUIRED
(not included)
PARTS LIST
A
B
C
D
E
Drawer (Qty 2)
Drawer Front (Qty 2)
Drawer Slide (Qty 4)
Shelf Slide (Qty 4)
Drawer Knob (Qty 2)
F
G
H
I
Screw, 5/8" (Qty 8)
Screw, 5/8" (Qty 8)
Screw, 1.0" (Qty 4)
Screw, 1.5" (Qty 2)
NOTE: Each set of Drawer Slides (C) and Shelf Slides (D) are shipped assembled. To separate, lift the plastic
catch on the Drawer SLide and pull the Slide out of the Shelf Slide.
ASSEMBLY AND
INSTALLATION INSTRUCTIONS
DRAWER KITS

2
3
C
G
G
C
2.1 Position Drawer Front (B) on each Drawer (A) and align mounting holes in Drawer Front with mating holes in
Drawer.
Install one 1.0" Screw (H) and tighten just until Screw catches. Install second Screw (H) in diagonally opposite
hole and tighten just until Screw catches.
Make sure remaining mounting holes are properly aligned, then install two remainings Screws (H) and tighten all
Screws.
3.1
3.2
3.3
For each Drawer, position Drawer Slide (C) against Drawer with
front end of Slide flush and square with rear side of Drawer Front,
then secure with two 0.445" Screws (G) at locations shown.
Repeat for second Drawer Slide (C).
If desired, install Drawer Knob (E) on each Drawer and secure with one
1.5" Screw (I). Alternatively, you can install a 96mm Drawer Pull
(purchased separately).
NOTE: DO NOT overtighten Screws (H) or surface of Drawer Fronts (B) may become dimpled.
G
G
H
H
H
H
B
A
E
G
I
ASSEMBLY AND
INSTALLATION INSTRUCTIONS
DRAWER KITS

DD
F
F
4
4.1
4.2
For each Drawer, position Shelf Slide (D) over pre-
drilled holes in shelf side panel, then secure with
two 5/8" Screws (F) at locations shown.
Repeat for second Shelf Slide (D).
Tip: For best results, use a small level to ensure
Shelf Slides (D) are properly positioned before
tightening.
F
D
ASSEMBLY AND
INSTALLATION INSTRUCTIONS
DRAWER KITS

5
5.1 Slide each Drawer onto Shelf Slides until
slides latch.
ASSEMBLY AND
INSTALLATION INSTRUCTIONS
DRAWER KITS