modway EEI-2920 User manual

EEI–2920 Dining Chair
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 1 of 4
Thank you for purchasing the MODWAY DINING CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 45 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
Hardware:
A. Bolt M6x45mm x 12
B. Flat Washer M6 x 12
C. Allen Wrench M4 x1
Component:
1 Chair Back x1 2 Chair Seat x1 3 Left Arm x1 4 Right Arm x1 5 Seat Cushion x1

EEI–2920 Dining Chair
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 2 of 4
STEP 1:
Please put Chair Back (1) on a carpeted or padded area.
Place Chair Seat (2) to Chair Back (1) as shown.
Insert 2 piece of Bolt (A) with 2 piece of Flat Washer (B) into the holes on Chair Back (1) through the holes on
Chair Seat (2).
Use Allen Wrench (C) to tighten Bolts (A). Do not fully tighten Bolts (A) at this step.
Hardware & Tools required
STEP 2:
Put the assembled Chair Back (1) and Chair Seat (2) to Left Arm (3) as shown.
Insert 5 pieces of Bolt (A) with 5 pieces of Flat Washer (B) into the holes on Left Arm (3) through the holes on
Chair Back (1) and Chair Seat (2) .
Use Allen Wrench (C) to tighten Bolts (A). Do not fully tighten Bolts (A) at this step.
Hardware & Tools required

EEI–2920 Dining Chair
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 3 of 4
STEP 3:
Put assembled chair unit to Right Arm (4) as shown.
Insert 5 pieces of Bolt (A) with 5 pieces of Flat Washer (B) into the holes on Right Arm (4) through the holes on
Chair Back (1) and Chair Seat (2) .
Use Allen Wrench (C) to tighten Bolts (A). Do not fully tighten Bolts (A) at this step.
Hardware & Tools required
STEP 4:
Use Allen Wrench (C) to tighten all Bolts (A) clockwise until secure.

EEI–2920 Dining Chair
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 4 of 4
STEP 5:
Please carefully turn over the assembled chair.
Put Seat Cushion (5) to the assembled chair as shown.
STEP 6:
Assembly is complete. Your dining chair is ready to be used now!