Mopec BD093 User manual

MOPEC USER MANUAL
HOW TO ATTACH YOUR BD093 BONE DUST VACUUM
COLLECTOR TO YOUR BD090 MOPEC SWORDFISH AUTOPSY
SAW

WHAT YOU NEED
A. Vacuum Unit
B. Chassis Base with Wheels
C. Vacuum Hose with Connector Ends
D. 6 Black Tube Clips
E. 4 M4 x 12mm Socket Head Screws
F. Silicon Hood
G. 1 M3 Hex Head Wrench
H. SOLD SEPERATELY: Mopec Swordfish Autopsy Saw & Power Supply Unit
I. NOT INCLUDED: Screwdriver
2

INSTRUCTIONS
1. Make sure nothing is turned on or plugged into an electrical plug. Remove the main
power lead and handpiece connectors from the Swordfish Power Supply Unit.
2. Flip the power supply unit over and remove the sticky feet from the base. Use a flat
screwdriver as a lever if necessary.
3

3. Flip power supply unit back over. Using a cross head screwdriver, unscrew the 4 corner
screws to remove the lid. Set lid aside.
4. Once the lid is removed, place the 4 M4 x 12mm socket head screws (E) down into the
holes next to the corner screw holes. Ensure that the screws protrude through the base.
5. Lay the vacuum unit (A) on its back with the blue front panel facing upwards. Align the 4
M4 screws in the power supply unit with the 4 holes on the front panel of the vacuum
unit. Once aligned, use the M3 hex head wrench (G) to tighten down the 4 M4 screws
onto the front panel until tight. Be careful not to overtighten.
4

6. Replace the power supply lid and screw in the 4 screws you removed in step 3. Again,
tighten down to properly seal the lid but be careful not to overtighten.
7. Remove the left-hand side protective cap (if not done already) from the base of the
power supply. Attach the lead from the vacuum unit and tighten. The connector will only
fit in one position.
5

8. Place the vacuum unit into the chassis base (B) with the wing nut and bolt in line with the
power supply facing forwards. Tighten the wing nut and bolt to keep vacuum unit in
place.
9. Replace the main power lead cable into the right-hand side socket of the base of the
power supply unit. Connect the main power lead to the chassis using the white cable clip
and screw.
6

10. Place the Mopec Swordfish into the handpiece holder. Run the handpiece cable
counter-clockwise around the back of the vacuum unit and feed it through the handle of
the vacuum unit. Connect the cable socket to the top of the power supply unit.
11. Place the silicon hood over the blade on the saw head and slide onto the saw body.
Make sure to slide the silicon hood all the way down. Return to the handpiece holder.
7

12. Grab the vacuum hose (C) and place the large end into the vacuum unit aluminum
socket on top, and connect the small end into the silicon hood.
13. Use the 6 black tube clips to attach the saw cable to the vacuum hose at regular
intervals. Once the main power unit is plugged into an electrical outlet, the yellow button
on the Mopec Swordfish will control both the oscillation saw and the vacuum unit. When
switched off, the vacuum will continue to run for a few seconds to clear any debris in the
vacuum hose.
14. The paper filter should be changed daily after usage as per the operating manual.
Please consult the manual for filter changes and maintenance.
8

THE BELOW IMAGE INDICATES HOW THE FULL UNIT LOOKS WHEN
COMPLETE:
9