Motorola i30sx Guide

135
i30sx Faceplates and Keypads
Your i30sx phone comes with a standard faceplate and keypad. You can order
additional face plates and keypads to change the look of your phone.
The following steps and accompanying illustration detail the procedure for
removing and replacing the changeable faceplate and keypad.
NOTE:Before replacing the faceplate, ensure that the keypad is
present and undamaged. For security and operational reasons,
power to the i30sx phone should be off prior to performing the
removal and replacement procedure. There is a protective
plastic liner over the lens. Peel off prior to operation.
Removal and Replacement Procedure
1 While holding the back of the phone, press the
faceplate release button located at the bottom of
the phone to release the faceplate. When you
press the release button, ensure that both sides
are disengaged from the faceplate prior to
removal.
2 In an upward motion, grasp the bottom part of the faceplate and detach
it from the phone.
3 Remove the keypad from the phone (or from the faceplate).
Release Button

4 To replace the faceplate and keypad, lay the keypad on the phone body.
5 As shown in the illustration, attach the faceplate to the phone body, first
at the top and then at the bottom. The top of the faceplate needs to be
securely seated into the top of the phone. Rotate faceplate towards
bottom of the phone until the lower snaps are engaged. Snap
engagement will be verified by a clicking sound. After the lower snaps
are engaged, verify that the middle of the faceplate is engaged by
pressing the faceplate near the sand rkeys. This will be verified by
a clicking sound.
6 Re-apply power to the phone by pressing and holding pnear the
bottom of the phone until the status light glows red and a tone briefly
sounds.