MPK 4750.1LW-K User manual

1 Stand 01.2021
MPK Metall- und
Plastikverarbeitung GmbH & Co. KG
Friedrich-Ebert-Str. 298-300
D-58566 Kierspe
mpk-kierspe.de
Side covers with LED-lighting
for inner frame with pleated blind and net 4750P
Side covers 4750.1LW-K
Technische Daten:
EN Installation and Operating Instructions
Please read the instructions carefully before installing and store it for future.
We cannot be held responsible for incorrect fitting, handling or operation.
Any product faults relating to the production and materials used should be notified to us via
an authorised dealer immediately.
Included with delivery
2x Side cover with LED-lighting
1x Polyswitch fuse
1x Connection cable
Explanation of symbols
Safety and installation instructions
Make sure that there is a suitable supply line and switch for the lighting in the vehicle.
Turn off the power supply in the vehicle before proceeding with the connection
of the LED lighting.
Wiring LED-lighting:
Installation
To fit the inner frame, gently pull out the pointed ends of the
cover profiles to release them and reveal the fixing points.
Remove the inner frame by loosening the four screws that
secure the frame.
Insert the supplied Polyswitch fuse into the inner frame so that
one connector sticks out on the right and one on the left side
of the inner frame.
LED-light
575 x 9 x 2,5 mm
Light color
~ 3000 K (warm white)
Energy efficiency class
A+
Nom. useful liminous flux
2 x 500 lm
Voltage
12 -14V DC
Condumption
2 x 5,6 kW/h / 1000h
Nominal lifetime
10.000h
No. of switching cycles
50.000
Warm up time
<1sek.
Nominal beam angle
60°
NOTE
Particulary important information.
ATTENTION!
Failure to observe can lead to material damage.
WARNING!
Safety note: Serious risk of injury.

2 Stand 01.2021
Connect the supplied connection cable to the power supply
installed in the vehicle.
Connect the Polyswitch cable of the inner frame to the power
supply of the vehicle. Then place the inner frame in the center
of the cutout.
Fix the connector from the inner frame with the connector from
the side panel before inserting the side cover.
Refit the inner frame covers by locating the securing lugs
and keeping the covers parallel against the roof whilst sliding
them carefully onto the frame, ‘clicking’ back into position,
without distorting.
Warranty
The legal warranty applies.
Disposal
Dispose of the appliance and packaging must be effected in accordance with
the corresponding local regulations and requirements for electrical appliances
and packaging.
mpk-kierspe.de/Downloads