MPK 4750.1 User manual

1 Stand 09.2021
MPK Metall- und
Plastikverarbeitung GmbH & Co. KG
Friedrich-Ebert-Str. 298-300
D-58566 Kierspe
mpk-kierspe.de
Side covers with LED-lighting
for inner frame with pleated blind and net 4750P and 7550P
Side covers 4750.1
Technical Data:
Side covers 7550.1 Technical Data:
EN Installation and Operating Instructions
Please read the instructions carefully before installing and store it for future.
We cannot be held responsible for incorrect fitting, handling or operation.
Any product faults relating to the production and materials used should be notified to us via
an authorised dealer immediately.
Included with delivery
2x Side cover with LED-lighting
1x Polyswitch fuse
1x Connection cable
Explanation of symbols
Safety and installation instructions
Make sure that there is a suitable supply line and switch for the lighting in the vehicle.
Turn off the power supply in the vehicle before proceeding with the connection
of the LED lighting.
Wiring LED-lighting:
Installation
To fit the inner frame, gently pull out the pointed ends of the
cover profiles to release them and reveal the fixing points.
Remove the inner frame by loosening the four screws that
secure the frame.
Insert the supplied Polyswitch fuse into the inner frame so that
one connector sticks out on the right and one on the left side
of the inner frame.
Light color
~ 3000 K (warmwhite)
Energy efficiency class
Nom. useful liminous flux
2 x 490 lm
Voltage
12V DC
Condumption
2 x 4 kW/h / 1000h
Nominal lifetime
50.000 h
Dimensions
400 x 10 mm
Light color
~ 3000 K (warmwhite)
Energy efficiency class
Nom. useful liminous flux
2 x 590 lm
Voltage
12V DC
Condumption
2 x 6 kW/h / 1000h
Nominal lifetime
50.000 h
Dimensions
575 x 8 mm
NOTE
Particulary important information.
ATTENTION!
Failure to observe can lead to material damage.
WARNING!
Safety note: Serious risk of injury.

2 Stand 09.2021
Connect the supplied connection cable to the power supply
installed in the vehicle.
Connect the Polyswitch cable of the inner frame to the power
supply of the vehicle. Then place the inner frame in the center
of the cutout.
Fix the connector from the inner frame with the connector from
the side panel before inserting the side cover.
Refit the inner frame covers by locating the securing lugs
and keeping the covers parallel against the roof whilst sliding
them carefully onto the frame, ‘clicking’ back into position,
without distorting.
Warranty
The legal warranty applies.
Disposal
Articles and packaging must be disposed of in accordance with local legal
requirements, as well as regulations for the disposal of plastics, electrical waste and
packaging.
mpk-kierspe.de/Downloads