MTD 19A30020OEM User manual

1. Place a bumper cap onto each end of the front bumper
tube. See Figure 1-2.
Figure 1-2
2. Position the bumper brackets to the inside of the tractor’s
frame and secure it in place with the four hex flange screws
or four hex screws and four flat washers, depending on
what this kit includes. See Figure 1-3.
Bumper mounts on the
inside of the tractor frame.
Figure 1-3
Model 19A30020OEM front bumper kit is designed for use with
select lawn tractors. Refer to your lawn tractor’s Operator’s
Manual to assure compatibility.
Carton Contents
Before beginning installation, remove all parts from the carton to
make sure everything is present. Carton contents are listed below
and shown in Figure 1-1. Part numbers are shown in parentheses.
• Two Bumper Caps (731-05368)
• One Bumper Assembly (683-05155)
• *Four Hex Flange Screws (710-06012A)
*Some Kits will have instead:
• Four Hex Screws (710-06012)
• Four Flat Washers (736-0262)
Figure 1-1
Installation Instructions
WARNING: Before beginning installation, place
the tractor on a firm and level surface, set the
parking brake, place the PTO in the disengaged
(OFF) position, stop the tractor’s engine and remove
the ignition key to prevent unintended starting.
InstallatIon Manual
Front Bumper Kit — 19A30020OEM
Form No. 769-09987B
January 20, 2015
MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA

To order replacement parts or locate your nearest service dealer call Customer Support at [phone].
or visit www.mtdproducts.com to find the nearest authorized dealer in your area