myPhone Fun 2 User manual

© 2014 myPhone. All rights reserved. myPhone FUN2 ENG
USER MANUAL:

Tech specification:
•RAM Memory: 512 MB
•4GB internal memory
•1750mAh battery
•input and output charger parameters: 100 240V AC,
50/60Hz, 150mA
-output: 5V DC, 1000mA
•Power the phone under standard conditions:
-5V DC, 500mA
•Smartphone`s weight: 219g netto/371g brutto
SIM card inserting
myPhone FUN2 is a mobile phone using
Dual SIM technology. Dual SIM allows you to use two mobile
netwo ks at the same time. To inse t the SIM ca d co ectly follow
the inst uctions:
•Tu n off the phone, emove the back cove (unde mining the
slot located in the left co ne of the base of the phone with
you nail) and pull out the batte y.
•Inse t the SIM ca d into the slot following the pictu es f om
above and below the socket.
MICRO SIM ADAPTERS
Do not install hollow (with no ca d) mic o-SIM ca d adapte in you
sma tphone. This will cause a jam. Attempt to d aw jammed adapte
back f om the slot can cause mechanical damage of the phone. If
SIM ca d adapte deadlocks in the socket, you should contact an
autho ized myPhone se vice!
Memory card inserting
Use only memo y ca ds compatible and app oved by myPhone.
Incompatible memo y ca d may damage itself and the device and
emove sto ed data. Incompatibility of memo y ca d can be caused
by inco ect ca d fo mat (mic o SD fo mat is equi ed) o
unsuppo ted ca d size (ove 32GB). To inse t the memo y ca d

co ectly follow the di ections:
•Tu n off the phone and take off the back cove (unde mining
the slot located in the left co ne of the base of the phone with
you nail).
•The memo y ca d slot is located above the batte y on the ight.
Following the d awing inse t the memo y ca d into the slot.
Battery inserting
To inse t the batte y:
•Tu n the phone back cove up.
•Take off the back cove (unde mining the slot located in the left
co ne of the base of the phone with you nail).
•Inse t the batte y (pay attention to the co ect o ientation of the
batte y contacts and phone contacts – these should be
adjacent to each othe ).
•Replace the back cove .
Battery charging
The batte y should be cha ged p io to the fi st tu ning on the
device. Cha ge the batte y with the kit cha ge . The device has a
batte y capacity of 1750mAh. In case of any p oblems with the
batte y - the device must be p ovided to myPhone se vice cente .
Use only cha ge s and cables app oved by myPhone. Using
unapp oved cha ge s o cables could cause an explosion o
damage the batte y in othe way.

Front view:

Rear view

N mber Symbol F nction
1 To ch screen 4.5"
2 Digital camera lens 0,3Mpx
3 Internal speaker
4 microphone
5 Men B tton
6 Home B tton
7 Back B tton
8 - Vol me control
9 - Keypad lock
10 M ltif nctional micro-B USB slot
11 Headphones slot mini jack 3.5mm
12 Digital camera lens 5.0Mpx
13 External speaker
The SIM card m st be inserted in s ch a manner as shown
in the fig res above and below the SIM socket. There are two
SIM card slots: SIM1 s pports WCDMA and GSM, and SIM2
s pports only the GSM network.
Turning on/off the phone
To t rn on the phone press and hold (for abo t 3 seconds)the

keypad lock key. To t rn the phone off press and hold (for
abo t 3 seconds) the keypad lock key and select: [Power off].
Indicator icons
Icon Description
Battery stat s
Active connection to a Wi-Fi network
New e-mail
New SMS
Network signal strength
Active 3G network
Active 2G network
Missed call
Active call
Held call
The device is connected to a comp ter
Active Bl etooth mode
Active alarm
Flying mode
Speakerphone
So nd profile set to vibrations

Declaration of conformity with EU Directives
myPhone Sp. z o.o. declares that this prod ct is
compatible with the essential req irements and other
important recommendations of the E ropean Directive
1999/5/EC – and all other EU directives.
On the website: www.myphone.pl/certyfikaty.aspx yo can see
the declaration of compliance for a given prod ct, choosing
its name from the list.
Attention: Some of the alerts in yo r phone may appear in
English.