1. Before the first start
SIM card installation
myPhone FUN 4 is a mobile phone ith Dual SIM technology, hich allo s you to use
t o mobile net orks simultaneously. First slot supports SIM or microSIM adapter, hile
the second slot microSIM cards only. To insert the SIM card properly proceed as follo s:
•Turn off the phone, remove the back cover (undermine it ith fingernail using a
slot designed for this purpose. It is located in the lo er right corner of the phone)
and remove the battery.
•Insert the SIM card into the slot according to the dra ings underneath the seat.
MICRO SIM ADAPTERS
Do not install empty microSIM card adapter ( ithout inserted micro card) in phone. The
adapter ill stuck in the phone. Attempts to take out stuck adapter from the slot can
cause mechanical damage to the phone. In such case immediately contact your
authorized myPhone service!
Memory card installation
Use only memory cards compatible and approved by myPhone. Incompatible memory
cards may damage the device, the card itself and lead all data loss. Incompatibility of
memory card can be caused by incorrect card format (requires microSD format) or
unsupported card size (over 32GB). To properly insert a memory card proceed:
• Turn off the phone, remove the back cover (undermine it ith fingernail using a slot
designed for this purpose. It is located in the lo er right corner of the phone) and
remove the battery.
• Insert the memory card into the slot according to the dra ings underneath the seat.
Charging the battery
Before you turn on the phone for the first time the battery needs to be charged. Charge
the battery ith charger included in the set. The capacity of battery is 1800 mAh. In case
of problems ith battery - the device should be delivered to myPhone service center.
You should only use chargers and cables approved by myPhone. Unauthorized chargers
or cables can cause the battery explosion and damage your device. When the battery
becomes lo , lo battery indicator appears on display. To continue using the device,
recharge the battery. When the battery is completely discharged the phone can`t be
turned on even hen loading is in progress. To turn it on again the battery needs to be
loaded for fe minutes.
To charge the battery:
1. Connect micro-B USB (trapeze) into the appropriate slot in myPhone FUN 4.
Improper connection of charger (USB cable) can damage your phone or AC
adapter. Any damages caused by misuse are not covered by the arranty.
