5 5
Pericardiocentesis Site
Remove the back panel. Close the clamp on the IV bag and fill with fluid. Use plain water for
easy cleanup, or add blood powder or methyl cellulose for added realism. Hang the bag no
more than 18" above the work surface. Feed the tubing through the hole in the neck. Attach the
pericardium bulb, open the clamp, and squeeze the bulb firmly two or three times to expel all
the air. Snap the bulb securely into the cage inside the body. (See Figure 7.) Replace the back
panel, top edge first, making sure that the clear support tube is seated in the holder on the
chest wall. Turn the manikin over and begin training.
To disassemble the system with minimum leakage, remove the bulb from the cage. (Do not
disconnect from the tubing.) Slide the open clamp close to the end of the tubing line, squeeze
the bulb to expel fluid, and close the clamp. Disconnect the bulb from the tubing. Drain all fluid
from the system, rinse if needed, and allow to dry.
Note: You may experience some leakage from the bulb, especially if it has been punctured
repeatedly. Leakage can be minimized by using the smallest needle size consistent with
accurate training, by rotating the bulb from time to time during use, and by keeping the IV bag
height as low as possible. Replace the bulb when leakage becomes severe. The outer skin pad
may also be replaced as needed.
CARE OF THE TRAINER
1. Normal soil may be removed from the skin with mild soap and water, or with Nasco
Cleaner (LF09919U).
2. Never place the skin on any printed material, as the ink will cause
indelible stains.
3. Handle synthetic blood with care, as it will stain fabrics, skin, and surfaces.
4. Rinse the fluid reservoir bag thoroughly after each use; leave the cap open so it can dry,
especially if it will be stored for any length of time.
5. Disassemble, rinse if needed, and drain the pericardiocentesis system. Allow all compo-
nents to air dry before storage.
6. Change the location of the IV bag clamp from time to time to prevent damage to the
tubing.
7. Do not expose the trainer to extreme temperatures.
Figure 7
Actual product may vary slightly from photo. Nasco reserves the right to change product
color, materials, supplies, or function as needed.
Pericardiocentesis Site
Remove the back panel. Close the clamp on the IV bag and fill with fluid. Use plain water for
easy cleanup, or add blood powder or methyl cellulose for added realism. Hang the bag no
more than 18" above the work surface. Feed the tubing through the hole in the neck. Attach the
pericardium bulb, open the clamp, and squeeze the bulb firmly two or three times to expel all
the air. Snap the bulb securely into the cage inside the body. (See Figure 7.) Replace the back
panel, top edge first, making sure that the clear support tube is seated in the holder on the
chest wall. Turn the manikin over and begin training.
To disassemble the system with minimum leakage, remove the bulb from the cage. (Do not
disconnect from the tubing.) Slide the open clamp close to the end of the tubing line, squeeze
the bulb to expel fluid, and close the clamp. Disconnect the bulb from the tubing. Drain all fluid
from the system, rinse if needed, and allow to dry.
Note: You may experience some leakage from the bulb, especially if it has been punctured
repeatedly. Leakage can be minimized by using the smallest needle size consistent with
accurate training, by rotating the bulb from time to time during use, and by keeping the IV bag
height as low as possible. Replace the bulb when leakage becomes severe. The outer skin pad
may also be replaced as needed.
CARE OF THE TRAINER
1. Normal soil may be removed from the skin with mild soap and water, or with Nasco
Cleaner (LF09919U).
2. Never place the skin on any printed material, as the ink will cause
indelible stains.
3. Handle synthetic blood with care, as it will stain fabrics, skin, and surfaces.
4. Rinse the fluid reservoir bag thoroughly after each use; leave the cap open so it can dry,
especially if it will be stored for any length of time.
5. Disassemble, rinse if needed, and drain the pericardiocentesis system. Allow all compo-
nents to air dry before storage.
6. Change the location of the IV bag clamp from time to time to prevent damage to the
tubing.
7. Do not expose the trainer to extreme temperatures.
Figure 7
Actual product may vary slightly from photo. Nasco reserves the right to change product
color, materials, supplies, or function as needed.
HC190001INM15.indd 11-12 2/5/19 3:45 PM