Nauticam N100 X1024-Z User manual

INSTRUCTION MANUAL
For N100 X1024-Z Zoom Gear for
Fujifilm FU INON XF10-24mmF4 R
OIS
PN# 36475
Thank you for your purchase of a NAUTICAM
product.
At NAUTICAM we pride ourselves in the ability to
recognize the requirements of professional as well
as amateur underwater photographers and fulfill
them through the innovative designs of our
products. We strive to achieve a high level of
user-friendliness by allowing stress-free
installation and easy operation of all important
functions of the camera.
Each product is individually inspected and water
pressure tested to ensure optimum quality.
Please read this manual carefully before using the
product this will maximize its performance as well
as its lifetime.
FORWORD
Current as of 1/16/2023

All NAUTICAM Products are warranted against
any material and manufacturing defects for two
years from the date of purchase for consumer
use. This warranty only applies to products
purchased from authorized NAUTICAM dealers
and does not extend beyond the original retail
purchaser.
To return your product for service please
contact your regional authorized service
center(s). Please note that this warranty only
applies when the product is purchased in the
territory where the service center is located.
NAUTICAM does not hold responsibility for
damage of any nature to any equipment used
with and/or placed within our products.
NAUTICAM accepts no liability for any loss of
captured images or the inability to capture
images even if it is due to the malfunctioning of
our products.
Unauthorized modifications and/or repairs of
our products will automatically invalidate the
warranty.
WARRANTY

IDENTIFICATION OF PARTS
Spare Rubber grips
Plastic C-ring
X1024-Z Zoom Gear

MOUNT THE GEAR ON A LENS
1. Insert the plastic C-ring as shown and
place it over the lens.
2 Insert the X1024-Z Zoom Gear on the
plastic C-ring until it reaches the
flange of the plastic C-ring.
3. To remove the X1024-Z Zoom Gear
reverse the above steps.
The tightness between the X1024-Z
Zoom Gear and the lens can be
adjusted by removing or adding rubber
grips on either sides of the plastic C-
ring spare rubber grips are included in
the package.

CONTROL THE GEAR
1. The X1024-Z Zoom Gear can be controlled by zoom/focus knob of the
housing.
After mount the camera and lens (with gear installed) on the housing
confirm that the zoom/focus knob operates correctly.

SPECIFICATIONS
#36475 N100 X1024-Z Zoom Gear for Fujifilm
FU INON XF10-24mmF4 R OIS
Dimensions: DIA87.0mm × 47.5mm
Type: Zoom gear
Compatible lens: Fujifilm FU INON XF10-
24mmF4 R OIS
Remark:
Nauticam supports only e-manuals. Please download
corresponding product manuals on google drive
https://bit.ly/Nauticammanual or contact us for e-
manuals.