Default Features
Initial Startup Programming
1.
From any display telephone, press
INTERCOM
+ Dial
#*#*
+ Enter the system password +
HOLD.
2.
The system passwords are:
-
632379 (NECDSX)
for Installer (level 3),
9999
for System Administrator 2 (level 2),
0000
for System
Administrator 1 (level 1).
1.
In
3101-01: Line Type
, assign the correct circuit type for each line. Analog line types are:
-
51
for loop start DTMF,
52
for loop start DP.
1.
In
2131-[01-64]: Line Access
, change each extension’s line access as required. The options are:
-
0
for no access,
1
for incoming access only,
2
for outgoing access only,
3
for full access
2.
Using
902x-Copy
may save you time.
1.
In
2132-[01-64]: Line Ringing
, set the ringing option for each extension, The options are:
-
0
for lamp only (no ringing) day and night,
1
for day and night ringing,
2
for night ringing only,
3
for delay
ringing day and night
2.
Using
902x-Copy
may save you time.
1.
Turn to the
System Programming Password Protection
feature to learn more about system passwords.
Default Features for Lines
1.
All lines are loop start DTMF.
• Use
3101-01: Line Type
to change this assignment.
2.
• Lines 1-12 ring on line keys 1-12 for extensions 300-315. (Lines 13-64 do not appear on line keys.)
• All other extensions are lamp only for lines 1-12.
3.
To customize line ringing, use one of the following:
• User Programmable Features code
#RAL
. (See the
User Programmable Features
feature for more.)
• Use
2132-[01-64]: Line Ringing
.
Default Features for Extensions
1.
The circuit types for keyset extensions are automatically set when the extension is plugged in.
2.
Keyset users can place outside calls by:
• Pressing a line key and dialing the outside number. (See the
Central Office Calls, Placing
feature for more.)
• Pressing
INTERCOM
, dialing 9, then dialing the outside number. (See the
Line Group Routing
feature for more.)
• Line Dial-Up and Direct Line Access are disabled. (See the
Central Office Calls, Placing
feature for more.)
3.
All extensions have full incoming and outgoing access to all outside lines.
• See
Initial Startup Programming
below to change this assignment.
4.
By default, Feature Keys 1-12 are line keys. Keys 13-24 are undefined. See the
Feature Keys
feature for more.
Default Features for IntraMail
1.
Each extension has an IntraMail voice mailbox.
2.
All mailboxes are enabled. To disable a mailbox, see
2141-01: Station Mailbox Type
.
3.
The IntraMail Automated Attendant does not answer outside calls. (See the
Automated Attendant
feature for more.)
1. Enter the programming mode.
2. Assign the correct circuit type to each of your installed lines.
3. By default, each extension has full incoming and outgoing access to each line.To change this assignment:
4.
By default, extensions 300-315 ring immediately day and night for lines 1-12. To change this assignment:
5. To change the default system passwords:
(1093088)
June 15, 2006, Rev 1
Printed in U.S.A.
Empowered by Innovation
