Neilsen CT2266 User manual

131PIECE THREAD REPAIR SET
CT2266
INSTRUCTION MANUAL
IMPORTANT:
These instructions accompanying the product are the original instructions. This
document is part of the product, keep it for the life of the product passing it on to
any subsequent holder of the product. Read all these instructions before
assembling, operating or maintaining this product.
Cannon Tools Limited
Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K.

1. SPECIFICATION
5pcs Installation Tools
5pcs Break Pin Tools
5pcs Twist Drills
1pc Hex Key
5pcs Taps
110pcs wire thread inserts:
M15 X 0.8 X 6.7mm
M6 X 1.0 X 8.0mm
M8 X 1.25 X 10.8mm
M10 X 1.5 X 13.5mm
M12 X 1.75 X 16.3mm
Warning: Wear approved safety glasses and ear defenders.
2. IMPORTANT SAFETY INFORMATION
a). Read the instruction manual fully. Do not attempt any operation until you have
read and understood this manual.
b). Most important you must know how to use the product.
c). Do not overload or misuse the tool. All tools are designed for a purpose and
are limited to what they are capable of doing. Overloading a tool will result in tool
failure and user injury.
d). Maintain your tools correctly. A well maintained tool will do the job safely.
Replace any damaged or missing parts immediately with original parts from the
manufacturer.
3. TECHNICAL DESCRIPTION

1.Twist Drill 5.2mm 2.Screw Tap M5x0.8
3.Installation Tool 4.Breaking Pin Tool
5.Twist Drill 6.3mm 6.Screw Tap M6x1.0
7.Installation Tool 8.Breaking Pin Tool
9.Twist Drill 8.3mm 10.Screw Tap M8x1.25
11.Installation Tool 12.Breaking Pin Tool
13.Twist Drill 10.5mm 14.Screw Tap M10x1.5
15.Installation Tool 16.Breaking Pin Tool
17.Twist Drill 12.5mm 18.Screw Tap M 12x1.75
19.Installation Tool 20.Breaking Pin Tool
Thread Insert 5mm Thread Insert 6mm
Thread Insert 8mm Thread Insert 10mm
Thread Insert 12mm
4. UNPACKING AND CHECKING
Carefully remove the product from the packaging and examine it for any sign of
damage that may have happened during shipping. Lay the contents out and
check them against the parts shown below. If any part is damaged or missing;
please contact the seller and do not attempt to use the product .

5. USING THE TOOL
1.Drill out the damaged thread using the correctly sized twist drill bit provided.
2.Tap drilled hole using screw tap provided.
3.Load thread insert into installation tool.
4.Screw insert into threaded hole.
5.Remove the tag from the using the breaking pin tool.
6.Thread is repaired and ready to use.
6. DISPOSAL
At the end of the machine's working life, or when it can no longer be repaired,
ensure that it is disposed of according to national regulations.
Contact your local authority for details of collection schemes in your area.
In all circumstances:
Do not dispose of this tool with domestic waste.

Do not incinerate.
During decommissioning of the equipment, certain hazards should be
understood and avoided:
Only with the line pressure released shall the equipment be disassembled.
7. EXPLANATION OF SYMBOLS
WARINING!
First read the instruction manual.
Wear safety glasses and ear protection.
Wear gloves.

CANNON TOOLS LTD
Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K.
Made in China