NetComm NB5PLUS4W Quick start guide

Upgrading the Firmware of the NB5PLUS4/W
1.) Go to the One page setup (i.e. 192.168.1.1). Enter the username ‘admin’ and
password ‘admin’ then click the ‘Advanced Settings’ located at the bottom left hand side.
2.) Click the ‘Tools’ Tab

3.) Click the ‘Update Gateway’ on the left hand Menu. Then specify the location of the
firmware by selecting the ‘Browse’ button. Then select the Update Gateway button.
**Please wait approximately 10 minutes for the NB5plus4/W to reboot. You may
then log back into the NB5Plus4/W to configure.