NetPay Pax A Series User manual

A920
QUICK
START
GUIDE
INITIAL DEVICE SETUP (IMPORTANT)
• TurnyourdeviceonandconnectittoyourWi-Finetwork.Waitforyour
conglestoinstall,thedevicewillrebootduringthisprocess.
• Oncerebooted,setyourdeviceSupervisorpassword,thedefault
usernameandpasswordis1234.
• Navigatetothe“AdminMenu”andtapthe“CycleKeys”functionto
establishaconnectiontotheacquirer.
!

2
Contactlessreader
Magstripe
reader
Volume
upbutton
Volume
down
button
Power
button
Micro
USBport
Cardreader
Device layout (front)

3
Paperrollreleaselatch
Batterycoverlock
Camera
scanner
Device layout (back)

4
Quick start guide
What’s in the box?
1xPAXA920terminal
1xUSBcable
1xUKACmainscable
1xPAXA920quickstartguide
1xThermalpaperroll
Initial device setup (IMPORTANT)
• Turnyourdeviceonandconnectittoyour
Wi-Finetwork.Waitforyourcongles
toinstall,thedevicewillrebootduring
thisprocess.
• Oncerebooted,setyourdevice
Supervisorpassword,thedefault
usernameandpasswordis1234.
• Navigatetothe“AdminMenu”andtapthe
“CycleKeys”functiontoestablisha
connectiontotheacquirer.
Changing the paper roll
• Openthepapercoverlatch,removeused
paperroll.
• Insertnewpaperrollwiththepaperpoking
outthetopofthedevice,adheringtothe
orientationshowninthepaperrollholder.
• Ensurethelidisfullyclosedsothatthe
paperfeedrollerfullyengagesthepaper.
Tearoffanyexcesspaper.
Changing the main battery
• Locatetherearbatterycoverandslidethe
open/closelocktotheright.
• Removethecoverandliftthebattery
byswingingitupwardsfromthebottom
andremove.
• Toinstallabattery,rstremove
theprotectivecoveroverthe
batteryconnectors.
• Insertthebatterywiththegoldconnectors
towardsthetoprightsidewhilstcarefully
pushingthebatteryloweredgeintoplace.
• Retandlockthebatterycover.
Power on
• Pressandholdthepowerbuttonforthree
secondsuntilthescreenpowerson.
Power off
• Pressandholdthepowerbuttonforthree
secondsuntilthepowermenuisshown.
• Tap“Poweroff”,andthen“Poweroff”
again.A“shuttingdown”messagewill
showwhentheterminalisturningoff.
Sleep mode
• Toputthedeviceinorwakethedevice
fromsleepmode,clickthepowerbutton.
Connecting to Wi-Fi
• Clickthethreelinesinthetopright
handcornerofthescreenandselect
Wi-FiSettings.
• Thedevicewillautomaticallysearch
andbringupavailableWi-Finetworks.
• Completetheconnectionprocessand
clickthebackarrowonthebottomleft
ofthescreenwhencomplete.