NexSens X2-Cell User manual

Serial Label
X2-Cell Quick Start
For best results, setup your new system in the office/lab. Collect a few data
points and become familiar with the system prior to field deployment.
1Go to V2.WQDataLIVE.com/Getting-Started
2Create a new account or sign into an existing account and enter the
Claim Code found on the serial label to access the device’s data
3Place the X2 in an area with
strong cellular coverage and
connect the antenna
4Remove the center power
plug and required outer port
plugs (1 for each sensor to
connect)
5Connect sensors to any outer
port (8 pin)
6Connect power (5 to 24VDC)
to the center port (6 pin)
7Wait up to 60 seconds for the blue cellular status LED to turn on
If the blue LED repeatedly blinks three times, the cellular strength is
sufficient to connect the X2 with WQData LIVE
If the blue LED repeatedly blinks once, cell coverage is low. Move the
X2 to a location with better cell coverage and cycle power
8Allow up to 5 minutes for sensor detection and data acquisition. The
detected X2 profile is sent to WQData LIVE along with new data
The blue LED will be on (solid) when setup is completed
9Refresh the web browser and confirm that all connected sensors and
their parameters are displayed on WQData LIVE

Troubleshooting
Symptom
Possible
Cause
Corrective Action
Claim code does
not work
Code was entered
wrong
Re-enter code exactly as shown on
serial label
Device was already
claimed
Check with previous owners/users
No LED activity
when power
plug connected
No power to the
device
Confirm the central power plug is
securely connected
Replace the battery pack
Device does not
show sensors
and parameters
or update new
data on WQData
LIVE
AND
Blue LED
repeatedly blinks
once
No cellular
coverage
Relocate the unit to an area with
strong cellular coverage and no
obstructions (outside in a parking
lot is typically good), then cycle the
power (Disconnect and reconnect
center power plug)
Sensors are
missing on
WQData LIVE
when setup is
complete
Sensors are not
configured properly
Confirm connected sensors do not
share SDI-12 or Modbus addresses
Sensors are not
supported
Confirm connected sensor is
compatible with the X2
Sensor is wired
incorrectly or
damaged
Ensure the sensor can properly
communicate directly without the
X2
For more assistance visit:
www.NexSens.com/Category/Knowledge-Base/X2-Data-Logger