NexSens G2-RAIN User manual

G2RAIN ALERT SYSTEM
QUICK START GUIDE
IMPORTANT - BEFORE FIELD DEPLOYMENT: Completely configure new G2 systems with a web connection in a near-
by work area. Operate the system for several hours and ensure correct sensor readings. Use this test run to become
familiar with the features and functions.
To get started:
a. Go to WQDataLIVE.com
b. Create a new account or sign into an existing
account.
c. Choose or create the project that will contain
the data logger by selecting the Projects link
from the bottom right footer of the page.
d. Open the project and go to the ADMIN tab
located at the top of the project dashboard
and click Settings.
From there, choose the Project/Site pull down
menu and select the site for the new data logger.
a. If a site has not been created, select New Site.
Enter the claim code listed below into the space
provided under Assigned Devices.
Remove the siphoning tipping bucket by using
the 9/64” hex wrench to loosen the (3) bolts
connecting the bucket and RTU.
a. Lift the bucket up gently.
b. Remove the rubbing band from the tipping
apparatus.
c. Reinstall the bucket and tighten bolts.

Figure 1: G2-RAIN Alert System
Overview
The G2-RAIN Alert System includes an integrated mo-
dem. Power is provided internally through (2) D-Cell
lithium batteries. An external power cable (optional ac-
cessory) allows connection to an SP-Series solar panel for
recharging the internal batteries and direct communica-
tion (serial to PC). The integrated tipping bucket supplies
accurate rainfall measurements (one tip per 0.01” rain).
Data is accessed and stored on the WQData LIVE web
datacenter. An easy-to-use dashboard and built-in sensor
library automatically facilitate setup and configuration.
What’s Included?
(1) G2-RAIN-RTU
(1) G2 series battery pack (installed)
(1) Rain gauge
(1) SMA antenna
(1) 9/64” hex wrench
(1) Quick start guide
Figure 2: Lift bucket to remove the
rubber band on the tipping apparatus.

937-426-2703
www.nexsens.com
2091 Exchange Court
Fairborn, Ohio 45324
Attach the antenna to the copper SMA connector
found on the bottom of the G2-RTU.
External power (Optional with purchase)- Connect
the G2-RTU adapter cable to an SP-Series solar
panel or an AC power adapter.
a. Listen for the single audible beep to confirm
power connection.
b. After a few seconds:
• Two beeps = sufficient cellular signal
• Three beeps = insufficient cellular signal

For additional information, please reference the G2-RAIN Resource Library on the NexSens Knowledge Base.
nexsens.com/g2rkb
Buzzer Event
When power is
applied
Beep Type
During telemetry
connection
Status
One short
beep
Two short
beeps
Three short
beeps
System boot
successful
Connection
successfully
established
No signal/connection
failed
During telemetry
connection
Figure 3: Rotate the antenna clockwise onto the
threads of the SMA connector.
Figure 4: Turn the black power set screw clockwise
to apply battery using internal batteries.
Buzzer Pattern Indicators
Table 1: G2-RAIN Buzzer Pattern Indicators.
Internal power- Use the included flathead
screwdriver to turn the black power set screw
clockwise on the bottom of the G2-RTU.
a. Listen for the single audible beep to confirm
power connection.
b. After a few seconds:
• Two beeps = sufficient cellular signal
• Three beeps = insufficient cellular signal
c. To power down, unscrew the set screw until
the o-ring is visible.

Figure 5: Connection of the G2-RTU external power
cable and an SP-Series solar panel.