Nice DS100 Technical specifications

Instructions and warnings for installation and use
Wireless Keypad
DS100
PUK CODE

2 – English
EN
Test the effective range of the keypad before fixing it. Place it on the wall
where it's to be mounted and enter the new PIN.
CAUTION: Position of the DS100 should be carefully considered.
In addition to the distance from the gate, avoid mounting it close to,
on metal that could block the signal.
A
B
C
1
248,&.29(59,(:
3INSTALLATION
The DS100 wireless keypad is a secure way to
operate Mhouseplus automation. (SeRKHJD@
QDLNSDBNMSQNKVHSG@RDBTQHSX/(-
A
B
C

English – 3
EN
1.
3.
2.
4.
2
1
2
Also take into consideration that when the batteries are low the
range can be reduced by 25÷30%.
Once the test has been done, fix the DS100 at a suitable height:
1. Undo the retaining screw
2. Remove the base and screw it to the wall
3. Connect the keypad to the base on the wall, hooking it to the upper part
of the support
4. Fix the keypad to the base

English – 5
EN
The DS100 will beep each time a button is pressed.
The DS100 cannot send a command until the PIN is set, after which the
A B C buttons can be used to send a command as normal.
The factory set PIN “11” can be changed at any time. See “PIN Change”
chapter 6.
The PIN can be a minimum of 1 number up to 10 numbers.
If no buttons are pushed within 10 seconds the PIN will have to be
introduced again.
If the PIN is incorrectly input, three rapid beeps when the wrong PIN is
entered.
5OPERATION
The orange button is used to illuminate the buttons at
night.
A series of rapid beeps confirms the command was sent.
A
B
C
1
Step-1: Enter your security PIN
Step-2: Press one of the A-B-C buttons to
send a command. When connected, each
A-B-C button will have a CHEEDQDMS command.
A: Step-by- step (Open/close)
B: Pedestrian open (partial open)
C: Open (stay open)
C
A
B
C
A
B

6 – English
EN
The following steps describe how to reset the PIN on a new DS100.
Any PIN change need the existing PIN as shown in Step 02. The PIN set at
the factory is 1-1.
PIN change process Example
01. Push orange button
02. Enter existing PIN
1 1
04. Enter new PIN (max. 10 numbers)
12 3
06. Confirm new PIN again
12 3
6PIN SET-UP
03.Push orange button
05.Push orange button
07.Push orange button

English – 7
EN
08. Three beeps confirm PIN is set.
Five rapid beeps indicate the PIN was
unsuccessful
Note: To use the DS100 without a PIN, follow the same process 'PIN change' process
without entering any PIN (steps 04 and 06).
If the PIN is forgotten it can be changed by entering the default “PUK
code” in step 02.
Each DS100 has its own 10 digit “PUK” code which can be found on the
cover of the printed manual sent in the box along with the DS100.
If the DS100 beeps 10 times when switched on, the batteries are flat. The
digital selector contains two CR2430 lithium batteries.
To replace the battery, proceed as shown.
7BATTERIES