Nilfisk-Advance Pacesetter 170 User manual

©2004 Printed in U.S.A, Nilfisk-Advance, Inc. 8/04 Form No. 56040838
page 1 of 2
Handle mounting arms are shipped
assembled as shown.
Remove Nut and Washer & re-
assemble with Compression
Lever Stud through Cord Hook
as shown. Tighten just enough
to hold Handle Tube in position
when Lever is DOWN.
DO NOT over tighten!
(13mm wrench)
Assemble Base Plate with Handle Tube
using hardware from plastic pouch as
shown.
(5mm Hex Key wrench)
Slide Cord Hook Assembly down handle
tube until it contacts stop screw in back
of handle tube.
Hold Compression Lever
DOWN while tightening
Nut at other end.
Connect Power Cords and
Plug Cover together.
Assemble (4) Washers & (4) Nuts from
bottom of Base as shown.
(10mm wrench)
“Snug” screw.
DO NOT OVER TIGHTEN!
Pacesetter 170 / 200 Assembly Instructions
Tools and Hardware needed for assembly are
included in plastic pouch inside of shipping carton.

8/04 Form No. 56040838
page 2 of 2
Connect Power Cords and
Plug Cover together.
Slide Cord Hook Assembly down handle tube
until it is about 2“ above the Handle cord.
Tighten (2) screws in Cord Hook
with 5mm Hex Key wrench.
Hold Handle Assembly Upright as
shown to assemble to base. Make
sure (4) holes in gear assembly are
oriented as shown with one at the TOP.
Install and snug (3) mounting bolts as shown while
holding Handle Assembly in place(upright)
DO NOT over tighten!
(6mm Hex Key Wrench & 13mm Open End Wrench)
Pacesetter 170HD / 200HD Assembly Instructions
Tools and Hardware needed for assembly are
included in plastic pouch inside of shipping carton.