Nilfisk-Advance Clarke CA60 User guide

Use and maintenance
Operating guidelines Clarke CA60 automatic scrubbers
1. Turn on the key and verify
there is enough battery power
to complete the work. Charge
batteries as required.
2. Install the squeegee us-
ing the thumb nuts. Attach
squeegee hose.
3. Remove the black cover on
the front and fill to desired lev-
el. Machine holds 16 gallons/61
liters maximum.
4. Check the water level indica-
tor on the right side of the
machine. Add appropriate
chemical.
5. Disc: Lift the brush/pad driver to engage the rush/pad holder
and rotate clockwise as viewed from above. BOOST: Simply press
the pad onto the pad driver face material.
6. Lower the brush deck by
pushing on the pedal to the
right and lift it up.
7. Press the OneTouchTM scrub
button to enable scrubbing.
The vacuum will start. Push
on one of the two switches
½ second to install the brush.
Brush will automatically install.
8. Use the squeegee raise/lower handle to
lower the squeegee to the floor.
Adjust the squeegee pitch as required.
9. Press left, right or both yellow palm
switches to move the machine forward.
12. Press the + or – solution buttons to
increase or decrease the water flow rate
and to turn water off.
10. Use the rabbit/turtle knob to control
the speed.
11. Pressing either yellow palm buttons
and the white reverse button together will
put the machine into reverse.
13. On disc machines, the brush/pad
holder can be removed automatically.
Raise the deck and press the click off brush
button.
Push
on the
button
by Nilfisk
September 2018 - Copyright © Nilfisk Group 2018 - www.clarkeus.com
Nilfisk, Inc.
9435 Winnetka Avenue North
Brooklyn Park, MN 55445
Phone: [phone]
Fax: [phone]
www.clarkeus.com
Nilfisk Canada Co.
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
Phone: [phone]
Fax: [phone]
www.nilfisk-advance.ca

Maintenance
Operating guidelines Clarke CA60 automatic scrubbers
September 2018 - Copyright © Nilfisk Group 2018 - www.clarkeus.com
1. When scrubbing is
complete, turn off the key
and perform the following
maintenance.
2. Daily: Empty the clean
water tank using the solu-
tion tank drain hose and
sight tube.
3. Daily: Empty the dirty
water tank using the
recovery water dump hose.
4. Daily: Inspect and rinse the
ball float cage and the foam
filter, debris catch cage and
inspect and clean the gasket
as required.
by Nilfisk
Local Clarke dealer:
Phone number:
SN:
5. Daily: Remove the squeegee, and clean.
Inspect the blades and flip them or replace
them as required.
8. Daily: Charge the machine when not in
use using the supplied AC cord and on-
board charger receptacle.
6. Weekly: Inspect the solution filter and
clean as required.
9. Daily: Charge the machine overnight and check the status using the battery status
gauge.
7. Daily: Leave the recovery tank lid open
after cleaning, to let the tank air.
Nilfisk, Inc.
9435 Winnetka Avenue North
Brooklyn Park, MN 55445
Phone: [phone]
Fax: [phone]
www.clarkeus.com
Nilfisk Canada Co.
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
Phone: [phone]
Fax: [phone]
www.nilfisk-advance.ca