Nipro TRUEdraw User manual

Parts of Your Lancing Device...
End Cap for
Finger Testing
Lancet Top
Holder
Trigger
Button
Arming
Barrel
Depth Dial
Gray Alignment
Arrow Ensures
Accurate Depth
Selection
Reinforced
Internal Design
for Improved
Durability
Lancing device is for self-testing and intended for use
by one patient only. Make sure you change to a new lancet
for every blood sample.
Since the lancet penetrates the skin, hygiene is very
important. New, unused Nipro lancets are guaranteed
to be sterile. After use they can easily be
discarded without touching them.
Obtaining Samples For
Blood Glucose Testing
Ph 1800 451 737
Nipro Australia Pty Ltd
www.niproaustralia.com.au

How to Use Your TRUEdraw
Lancing Device
1. Select area to be lanced. Wash with
soap and warm water, rinse and dry
2. While holding Arming Barrel,
pull off End Cap.
3. Push Lancet into Holder until firmly
seated. Then replace end cap.
Note: Use clear End Cap for
lancing forearm.
4. Turn Depth Dial to desired lancing
depth for personal comfort.
5. While holding End Cap in one hand,
use other hand to gently pull back
Arming Barrel until a click is heard.
6. Firmly place Tip against finger and
press trigger button. Note: For best
results, lance in highlighted areas.
7. Allow a blood drop to form and touch
the tip of the strip to the top of the
blood drop.
Refer to owner’s booklet for instructions & for information about testing on forearms.