Noble House Home Furnishings Ottoman User manual

Assembly Instructions
Caution: You must read this before you proceed
Ottoman
Caution: This Table is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Table and to prevent damage to the Table, two
adults are required to execute these actions.
Noble House Home Furnishings LLC 1 of 6

Label Qty
O 2
P 2
Q 1
R 1
No. Qty
⑦9
⑧5
⑨1
Part List
Picture
Description
Picture
Description
Leg Panel
Side Panel
Seat Panel
Seat Cushion
Hardware
Bolt
(M6x40mm)
Screw
(M6x55mm)
Allen Key
Noble House Home Furnishings LLC 2 of 6

Assembly Preparation
Before Beginning Assembly:
Assembly Steps
Overview
This Ottoman has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Ottoman parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions below to familiarise yourself
with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
FRONT FACING
Seat Panel (Q)
Side Panel (P)
Leg Panel (O)
Seat Cushion (R)
Noble House Home Furnishings LLC 3 of 6

Step 3
Step 2
Place Leg Panel(O ) facedown as pictured above.
Insert the tenons on Side Panels(P ) into the mortises of Leg Panel(O ).
Attach Side Panels(P ) to Leg Panel(O ) using Bolts(⑦) with Allen Key(⑨).
Repeat the same process with the remaining Leg Panel(O ).
Do not fully tighten the Bolts.
Insert Seat Panel(Q ) into assembled Ottoman frame as pictured above.
Attach Seat Panel(Q ) to Side Panels(P ) using Screws(⑧) with Allen Key(⑨).
Note: Insert Screws(⑧) from inside to outside of Seat Panel(Q ).
Do not fully tighten the Screws.
Noble House Home Furnishings LLC 4 of 6

Step 4
Place the Ottoman onto a flat, level surface.
Then EXERT pressure, floorwards onto the Ottoman with both hands.
This pressure will help the Ottoman reach full alignment at all joints.
In a sequential manner, gradually tighten all Bolts and Screws at all joints until evenly
secured.
Inspect the Ottoman and make sure all parts are adequately connected.
Adjust the Levellers until the Chair is level with the ground.
To adjust the Levellers, get assistance from an adult partner to lift/lean and hold
the Chair while you are working.
Step 5
Place Seat Cushion(R ) onto Seat Panel(Q ), then tie the velcro straps around Seat
Panel(Q ) as pictured.
Your Ottoman is ready for use.
This Ottoman can only be used on a flat, level surface.
Adjust Pre-installed
Noble House Home Furnishings LLC 5 of 6

Noble House Home Furnishings LLC 6 of 6