VISIONARY DESIGNS MOD-1450 Manual

© 2019
Order #XXXXX
Completed Assembly
Underside View
Base
Table Top
Post
Steps:
1) Connect base to post, using bolt.
2) Route cord from table top through post and base.
3) Connect table top to post, with fixed brackets, using bolts.
MOD-1450 Charging Table
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2019
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
LADDERS OR LIFTS
MAY BE REQUIRED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
Controlling the RGB LED lights
Function of Keys
Receiver:
1. Working voltage: DC12V/24V
2. Output: Max. 6A/Channel
Total output Max. 10A
3. Max standby power: 0.5W
Remote Control:
1. Working voltage: 3V
2. Standby power: <20uA
3. Transmitting power: 6dBm
Specifications:
Static Mode:
1. Use the Color Ring key to select a color.
2. Saturation is controlled with W/R/G/B keys.
3. White mode is available by long-pressing ‘ON’ key.
4. Colors (not white) are dimmable with the
Brightness key.
Dynamic Mode:
Press "M" key to cycle through the following options:
1. White light fades in and out.
2. Several colors fade in and out.
3. R,G,B three colors fade in and out.
4. R,G,B three colors flash.
5. Six colors flash.
6. Random color flashes.
7. Red color fades in and flashes.
8. Green color fades in and flashes.
9. Blue color fades in and flashes.
To Pair a Remote with Multiple Units:
1. Power on the lights.
2. Press ‘ON’ key within 3 seconds.
3. Lights will blink when link is made.
To unpair: Long press ‘ON’ key within 3 seconds
after switching on lights.
Remotes can be paired with one or more receivers.
Different receivers can work synchronously even
when started at different times (within 30 min).
Master ON
Mode (M)
White +/-
Red +/- Green +/-
Blue +/-
Brightness - Brightness +
Color Ring
W R G B
ON
S- M S+
OFF
Indicator
Master OFF
Speed - Speed +
General Information