Noble House Home Furnishings Table User manual

Label Picture Description QTY
A Table top 1
B Table Leg 2
C Support Rod 1
Caution : Please read this carefully before you proceed
Please look in Red Bag for hardware packs and legs.
Table
Noble House Home Furnishings LLC Page 1 OF 5

Label Picture Description QTY
①Bolt
(M6x14mm) 5
②Bolt
(M6x30mm) 3
③Allen Key 1
④Washer 5
Before
Beginning
Assembly
Noble House Home Furnishings LLC Page 2 OF 5

Step 1
Overview
This Table has multiple parts and may require up to 20 minutes to assemble. To give
you an overview of the Table parts, the above picture is provided to help you put the
various parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.
Attach the Support Rod (C) to Table Leg (B) with Bolts(②) using the Allen Key (③).
Front Facing
Table Top(A)
Support Rod(C)
Table Leg(B)
B
C
②
Noble House Home Furnishings LLC Page 3 OF 5

Step 2
Step 3
Attach the Support Rod (C) to Table Leg (B) with Bolts(②) using the Allen Key (③).
B
C
②
B
A
Noble House Home Furnishings LLC Page 4 OF 5

Step 4
Place the side table on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected, then proceed to tighten
the screws in a sequential manner.
CAUTION 1: When tightening these screws, tighten sequentially. DO NOT fully tighten
any screw and then move on to the next one, as this could cause the frame to warp.
Ensure all screws are fully locked into position.
The table is ready to be used.
Caution 2: This table should only be used on a flat, level surface.
Attach Table Leg (B) to Table Top (A) with Bolts(①) and Washers (④) using the Allen
Key (③).
Do not fully tighten the Bolts.
Noble House Home Furnishings LLC Page 5 OF 5