North Light 32-9058 User manual

Stolplykta
Hagelykt
Lyhtypylväs
Art.no.
32-9058
36-3753
ENGLISHSVENSKANORSKSUOMI
Lamp Post
Ver. 200911

3
ENGLISH
Lamp Post
Art. no 32-9058
36-3753
Please read the entire instruction manual before using the product and save it
for future reference. We reserve the right for any errors in text or images and any
necessary changes made to technical data. If you have any questions regarding
technical problems please contact Customer Services (see address on reverse).
Safety
Caution! All light ttings must be installed in accordance with current safety
regulations to prevent life-threatening accidents. The installation should only be
performed by competent persons with a good knowledge of electrical wiring. If in
doubt, contact a qualied electrician.
Follow the instructions carefully and keep them for future reference.
The lamp comes with a rubber seal. This rubber seal must be used to ensure that
the lamp is watertight. Fit the rubber seal as shown in the picture below, making
sure that it is seated properly on the lamp base. This not only applies to initial
assembly but also to any subsequent light bulb changes.
Glass shade
Lamp housing
Rubber seal
Lamp base

4
ENGLISH
Fig. 1
Fig. 2 Fig. 3
Installation
1. Turn off the power at the main switch in fuse box before beginning the
installation (see g. 1).
2. Remove the glass shade by holding it at the top and turning it anticlockwise. Note
that the top of the light tting will come away with the glass shade (see g. 2).
3. Screw the lamp post to the foundation. The lamp post should always be posi-
tioned where it is stable and not able to be knocked down.
4. Undo the three screws holding the lamp base to the post. Pull the light tting
and connection block out of the post and connect the electric cable to the ter-
minals as shown in the diagram (see g. 3). If the electric cable is too thick to
t two in one strain relief, use two strain reliefs with one cable in each.
There are two earth terminals. If you are using a thin cable, you should use the
earth terminal on the white connection block. If you are using a cable with a braid-
ed earth, you should use another earthing point such as the metal plate that the
strain relief is attached to.
5. Attach the lamp base to the post using the three screws.
Blue (neutral) con-
nects to the terminal
marked “N”.
Brown or black (live)
connect to the “L”
terminal.
Yellow-green (earth)
connects to the screw
marked with the earth
symbol .

5
ENGLISH
Fig. 4 Fig. 5
Disposal
Follow local ordinances when disposing of this product. If you are unsure of how to
dispose of this product, please contact your municipality.
Specifications
Art.no: 32-9058, 36-3753
Voltage 230 V AC, 50 Hz
Bulb Max. 1 x 60 W, E27
Protection class IP23
6. Insert a bulb (Max 60 W, E27) (see g. 4).
7. Attach the glass shade and screw on the top of the light tting (see g. 5).
8. Reconnect the mains power at the fuse box and the lamp is ready for use.