Nucraft Two4Six Meeting Table User manual

Two4Six Freestanding Table
Installation Instructions
ID:

Before Beginning Installation
•Read through the entire instruction thoroughly
•A minimum of 2 persons is required for this assembly
•These instructions reflect typical assemblies. They may not match your specific configuration.

Required Tools
•Drill Driver
•#2 and #3 Phillips Bit
•Level

Top Shapes
Rectangle Soft Rectangle

Step 1: Open Frame Setup
•Align the holes in the top plate of the open frame base to the two predrilled holes in the table top.
•Be sure the “T” shape of the base are as shown below.
•Secure with screws
•NOTE: DO NOT overtighten the screws as this may damage the work surface.

Step 2: Modesty Attachment
•Attach the modesty at the 2 predrilled locations.
•Once these 2 fasteners are tightened, insert remaining HW0747 fasteners into the modesty bracket.
•NOTE: DO NOT overtighten the screws as this may damage the top.

Step 3: Level Table
•Place level on top, running along the length of the top.
•Check for levelness and extend or retract glides as needed.
•Repeat the above procedure along the width of the top.
•Double check both directions.
•NOTE: Glides are located on bottom of base for adjustment.

Step 4: Installing Power Rails (If applicable)
•Insert thumbscrews into predrilled holes on the bottom of the table top.
•Part can be attached at ends or along the length of the table.
•Additionally the power rail can be adjusted toward or away from the edge of the table.

Step 5: Pencil Caddy (if applicable)
•Secure the pencil caddy by securing the black steel plate to the top.
•The tray will need to be rotated to secure all 4 screws.
•The pencil caddy can be installed to the customer’s preference (HW0741).