Nucraft Tesano Monitor Table User manual

Tesano Monitor Table
Installation Instructions
ID:

Before Beginning Installation
•Read through the entire instruction thoroughly
•A minimum of 1-2 persons is required for this assembly
•These instructions reflect typical assemblies. They may not match your specific configuration.

Required Tools
•Drill Driver
•#6 Hex Drill Bit
•Phillips Bit
•Bit Extender
•Level

Provided Hardware
HW0543
HW3774
HW2248
HW0747
HW0666
HW0615

Tesano Monitor Table

Tesano Monitor Table Exploded
1. Top
2. Monitor Panel
3. Column Base
4. Beams
5. Wire Management
6. Wood Rails
7. Apron
1
2
37
6
4
5

Step 1: Center Column and Beams
•Place column in desired location. Secure the support beams in place with fHW0543 screws and
HW3774 washers.
•Have a person or item to support the other end of the beams.
•NOTE: The beam ends that match with the column brackets are labeled.

Step 2: Monitor Panel
•Prop up the monitor panel to be in line with the support beams.
•Slide beams into brackets and secure with HW2248.
•NOTE: DO NOT tighten screws, but keep loose.

Step 3: Top
•Place top on to support beams.
–Keep the end of the top tight to the
monitor wall, no gap.
–Flush the sides of the top to the sides of
the monitor wall.
•Secure the top to the support, by inserting
HW0615 screws through the support beams into
the wood rails.
•Mending plate secure the top to the monitor
wall, with HW0747 screws.
Flush

90 degrees
Step 4: Level Monitor Panel
•Level the monitor panel to be straight.
•It is easy for the panel to veer left or right so be
sure it is at a right angle to the top.
•Now tighten the fasteners from earlier that attach
the monitor panel to the support beams.

Step 5: Rails and Aprons
Then add the aprons by securing with HW through the metal channel into the wood rail.

Front Panel
Step 6: Electrical
•The duplexes will already be attached to the
support beams.
•Connect the “U” shaped jumper to connect
the two duplexes.
•Connect the infeed wire to one of the
duplexes, and the other end will run out
through the column base.
•Attach the wire management by securing to
the support beams.
•NOTE: When securing the monitor screen to
the panel. Only attach through face panel
using the appropriate hardware. Do not secure
through back panel.