Nucraft Tavola Standing Height and Credenza User manual

Tavola Standing Height and Credenza Installation Instructions
Rev. 10/2014

Before Beginning Installation
Read through the entire instruction thoroughly
A minimum of 2 people are required for this
assembly
These instructions reflect typical assemblies; They
may not match your specific configuration

Required Tools and Hardware
Level
PODS For Glass Handling (where
applicable)

Tavola Standing Height Table

Tavola Standing Height Exploded
1.Frame
2.Side Panels
3.Top 1
3
2

Tavola Credenza

Tavola Credenza Exploded
1.Frame
2.Side Panels
3.Top
4.Case 1
3
2
4

Tavola Standing Height| 8
Step 1
Setting Glass
Locate credenza in its final
position
Make sure and level
Remove the cardboard spacers
Using suction pods, set the top
glass in place.