Nucraft Flow Wall Mounted Credenza User manual

Flow Wall Mounted Credenza
Installation Instructions
ID:

Before Beginning Installation
•Read through the entire instruction thoroughly
•A minimum of 2 persons is required for this assembly
•These instructions reflect typical assemblies. They may not match your specific configuration.
•NOTE: The architectural wall must be able to support 100 pounds of weight per linear foot of credenza.
–i.e. →an 8 foot credenza = 800 pounds of support.

Required Tools
•Drill Driver
•Phillips Head Screwdriver
•Tape Measure
•Level

Flow Wall Mounted Credenza

Step 1: Wall Z-brackets
Install Z-brackets on Wall:
1. Locate the position for the bottom Z-bracket. For a wall mounted credenza, with a top height of
29.5”, your bottom Z-bracket should be 13.75” from the floor.
–NOTE: Measure form the lowest point you can. Do not measure from the top of the carpet.
2. Secure the bottom Z-bracket into place, ensuring that it is level.
(continue on next page)

Step 1 cont: Wall Z-brackets
3. Locate and attach the second Z-bracket, above the first Z-bracket. There should be 10” of space
between the two Z-brackets. So, for wall-mounted credenza with a top height of 29.5”, your top Z-
bracket should be 25 & 5/16” from the floor. Again, ensure it is level.
4. Place the credenza on to the Z-brackets.
NOTE: If the wall is not plumb, it will make it difficult to engage the Z-brackets. It may be necessary to
shim the Z-brackets on the wall.

Cross Section of Architectural Wall