NU SKIN®FACIAL SPA
QUICK REFERENCE GUIDE
IMPORTANT: Read ALL contraindications, warnings, precautions, and adverse reactions listed
in the owner’s manual prior to use.
INSPECT YOUR DEVICE: Look at the Facial Spa and conductors to ensure the chrome surfaces
appear smooth. Do not use if you notice any sharp edges, blistering of the chrome, and/or abnormalities on
any surface. Call Nu Skin Support Services for a replacement or warranty information.
READ THE FACIAL SPA OWNER’S MANUAL BEFORE USING YOUR FACIAL SPA.
The BASIC REGIMEN has two five-minute spa sessions (10 minutes total) and is for the entire face.
Do NOT use Facial Spa more than three times per week.
NU SKIN® CONDUCTIVE GEL: Nu Skin®Conductive Gel MUST BE used with your spa device
to ensure adequate conductivity.
HOW TO USE:
PREPARE YOUR FACE: Cleanse and rinse your face with a gentle cleanser of
your choice.
BASIC REGIMEN—ENTIRE FACE (see Figu re 1)
SPA SESSION A
1. ATTACH CONDUCTOR AND APPLY GEL: Attach the LARGE conductor
to the device (see Figure 2) and apply a generous amount of Nu Skin Conductive
Gel (included)to the entire face (grey areas of Figure 1), avoiding eyes, eyelids, and
lips (white areas of Figure 1).
2. CHOOSE SPA SESSION NUMBER 4: Press the selection button once to turn
on the device and again as needed to advance to the next spa session number.
Advance through the spa session numbers until a number 4 is lit on the display
with 5 small dots (see Figure 3).
3. CONDUCT FACIAL SPA SESSION A:Holding the chrome plate with your moistened hand,
touch the conductor to your facial skin (see Figure 4). The device will beep indicating that spa
session A is beginning. Slowly glide the conductor over your face where the gel has been applied,
avoiding sensitive areas (eyelids, eyes, lips, and throat).
At the end of spa session A, the device will emit a long beep followed by two short beeps, indicating
that the spa session is complete.
SPA SESSION B
4. PREPARE: Before proceeding to spa session B, apply additional Nu Skin Conductive Gel to any
areas of the face where it may be drying out. Note: The LARGE conductor should already be attached.
5. CHOOSE SPA SESSION NUMBER 3: Press the selection button once to
turn on the device and again as needed to advance to the next spa session
number. Advance through the spa session numbers until a number 3 is lit on
the display with 5 small dots (see Figure 5).
6. CONDUCT FACIAL SPA SESSION B:Holding the chrome plate with
your moistened hand, touch the conductor to your facial skin (see Figure 4).
The device will beep, indicating that spa session B is beginning. Slowly glide
the conductor over your face where the gel has been applied, avoiding
sensitive areas (eyelids, eyes, lips, and throat).
At the end of spa session B, the device will emit a long beep followed by two
short beeps, indicating that the spa session is complete.
CLEAN AND PROPERLY STORE YOUR SPA DEVICE as directed in the
owner’s manual.
Spa Session A Spa Session B Conductor
94503523/3
Figure 1
Figure 2
Figure 3 Figure 5
Figure 4
