8 9
To activate the galvanic current: Your moistened hand must be touching the
chrome activators while the conductive surface makes contact with the treatment
area. Make sure that all contact points are thoroughly moistened. Remember, all
contact points must be wet to optimally conduct the galvanic current.
During treatment: The instrument will beep every 10 seconds to indicate the
unit is on and working. Once treatment time reaches 30 seconds remaining, it will
beep every 5 seconds until treatment is complete.
Treatment interruption: To maintain the galvanic current throughout the treatment, you
must keep the conductive surface in contact with the area being treated and ensure adequate
moisture at all contact points. Lifting the instrument or fingers/hand from the treatment area
or chrome activators will disrupt the current and interrupt the treatment. In this case, the back-
light will flash on and off and the instrument will stop beeping until the circuit is either reestab-
lished or until the instrument shuts off after two minutes of non-use.
Treatment completion: At the end of your treatment, the clock and number of minutes will
disappear, but the ageLOC rings will remain on the screen. A “treatment complete” sound will
also play simultaneously. If you wish to initiate another galvanic treatment, press
the on/off button and re-initiate the cycle. To turn the instrument off, simply press
the on/off button twice.
Optional Rubber Cover: Please refer to this illustration for applying the optional rubber cover to your Body Spa.
Following these general guidelines will assist you in operating your instrument. Please read
these instructions before beginning a treatment. Note: All contact points must be moistened
to optimally conduct the galvanic current.
Handling Your ageLOC Galvanic Body Spa: Firmly hold the device, ensuring contact with the
chrome activators (front) while not making contact with the ageLOC conductive surface (back), as
seen in the examples shown on the left.
Backlight: The backlight will remain lit while the instrument is on. If the backlight is blinking on and
off, it is either because the instrument has lost contact with your skin or there is not enough moisture
for optimal conductivity. To continue your spa treatment, ensure adequate moisture at all contact
points and resume contact with your skin.
Product application: Apply the treatment gel liberally to the area being treated.
Treatment selection: Press the on/off button once to turn on the instrument,
while holding the instrument as indicated above. The ageLOC rings appear in
the middle of the display and the treatment time of 5 minutes and clock
appears below the ageLOC rings. Thoroughly moisten your fingers and palm
with water or NaPCA Moisture Mist. In order for a treatment to begin, gently
touch the conductive surface against the treatment area for the current level to
self-adjust. The instrument will beep one, two, or three times, indicating that it
has self-adjusted to your skin.
Usage guidelines for your ageLOC® Galvanic Body Spa