1. General
2. Introduction
The LANRJ45C6P has been designed to provide protection to
Local Area Networks (LAN) from overvoltage surges and electro-
static discharges created by switching transients in buildings. LAN
systems are particularly prone to such disturbances because long
cable lenghts often behave like antennas to such atmosphereic
distrubances. The product is designed to fulfill all versions of POE
applications compatable with IEEE 802.af and IEEE 802.3at.
3. Quick Installation Overview
1. Mount the LANRJ45C6P onto grounded DIN rail
2. Connect the incomming data line into either port
of the LANRJ45C6P
3. Connect the outgoing data line into the
remaining open port of the LANRJ45C6P
4. Mounting
LANRJ45C6P is designed to
clip onto 35mm (top hat) DIN
rail (standard EN50022) set in
the horizontal position with the
securing clips towards the
bottom of the rail and the label
text facing the correct way up.
IP8362_B
INSTRUCTION SHEET
1 of 2
WARNING:
nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at
1.
www.nVent.com
and from your nVent customer service representative.
nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
completely
followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and/or death, and void your warranty.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by
nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change
specifications without prior notice.
© 2016-2019 nVent All Rights Reserved
TECHNICAL SUPPORT
www.nVent.com
