ODU MINI-SNAP K Series User manual

www.odu.de
A
Page 2
ODU MINI-SNAP Series L, K, B 010.014.000.000.000
Assembly Instructions
Assembly Unsealed Plugs, Series L (IP 50)
Housing
Insert with
solder capacity
Cable collet
Half-shells Back nut (style 1)
1. Slide back nut and cable collet (and possibly cable bend relief) over the cable.
2. Strip cable and wire
corresponding the table
(see page 18).
3. Pre-tinning of strands.
4. Solder each wire (A) to the
corresponding contact.
Back nut for
cable bend relief
(style 2)
Cable bend relief

www.odu.de
EF
B
CD
ODU MINI-SNAP Series L, K, B
Page 3
010.014.000.000.000
Assembly Instructions
5. Bend cable shield outwards,
assemble half-shells.
6. Slide the cable collet against the
half-shells and clamp the shield (B)
between it.
7. Now you can put the assembled
cable considering the guidings (C)
into the connector housing.
If necessary, secure thread (D) with
adhesive (see page 18).
8. Screw back nut on the assembled
plug, counterhold spanner at (E)
and tighten to spanner at (F) with
ODU spanner wrench.
Caution! Consider tightening
torque (see page 18).
The assembly is nished.