Ogawa OG-7010 User manual

OG-7010
OG-7010

OGAWA OG-7010.
OGAWA
Assembly Instructions
OG-7010 massage chair arrives in three boxes. The base is packed in box 1, the backrest is packed
in box 2, and the side boards packed in box 3. As pictured below.
Open box 1 and remove all the packing materials. Then take the base out of the box and get rid
of the plastic bag which covers the base. As pictured below.
2
Take the tablet holder from the footrest, remove the packing material and set aside.
The accessory box includes the power cord, user manual, instruction manual, warranty card, tablet cover,
and arm hardware. As pictured below.
3
1
1
Box 2: Backrest
Box 1:The Base
Box 3: Side Boards
OG-7010
OG-7010
OG-7010
USER MANUAL OG7010
OG7010

Remove the protective material. Remove the cotter pin and bolt and set aside.
Cut the cable tie, which is used to secure the backrest actuator while shipping.
Remove the protective material that is wrapped on the backrest actuator. Remove the cotter pin
and bolt and set aside. As pictured below.
4
Open box 2 and remove packing materials. Take the backrest out of the box and set it on the floor.
DO NOT pull on the air hose. DO NOT pull on the backrest cable. DO NOT pull on the pillow, or damage
could occur.
5
Preferably using two people, carefully set the backrest on the cradle points on the base.
With the backrest in a vertical position, ensure it properly engages to the base.
Caution: DO NOT rest the backrest onto floor while it is vertical otherwise damage to the backrest bracket
may occur.
6
Push the backrest forward and let it lean on the seat pad. Use the bolt and cotter pin to attach
the backrest and backrest actuator.
7
2 3
Remove the cardboard.
Remove the two screws.
Set the backrest on the cradle points on the base. the backrest properly engages to the base
Attach backrest bracket to reclining actuator. Lock the bolt by cotter pin.
Aline the two brackets.

The air hose must be upward.Locate the connecter on the inflator pump box.
Connect the backrest 4-way air hose connecter to the air pump box.
8
Locate connector on PCB tray. Securely attach the backrest harness to PCB tray and lock it by screws
on the connector.
9Open box 3 and remove the two side boards. Locate the two zipper heads at bottom edge of the
side board. Unzip these two zipper heads to both ends. On the side board, there are two metal plates.
Locate the hole under each metal plate. As pictured below.
11
Recline the backrest until it locks into position.
10
4 5
Connect the connector to the PCB tray.
Make sure to lock it by the screws.
Locate connector.
Unzip these two zipper heads to both ends.
Locate the hole under each metal plate.

Remove the protective cloth strips on the backrest pad and attach the backrest pad onto
backrest. Attach the zipper to the backrest pad. Then attach the pillow. As pictured below.
14
Connect the air hose and then the wire harness to their appropriate connectors. Carefully
attach the side board onto the base. Align and insert the two metal bars on the base into the holes under
the metal plate. As pictured below.
12
Use the two socket hexagon head screw to fix the side board. Then zip the zipper. As pictured below.
13
6 7
Connect the air hose and wire connecters.

15 Attach the tablet holder onto right side armrest. The attach the tablet onto the holder.
As pictured below.
16 Connect the chair to power supply, turn on the power switch. Then you can enjoy your
massage chair.
8
Locate the power switch