Olimpia splendid Caldostile F Parts list manual

Caldostile F
INSTRUCTIONS FOR INSTALLATION, USE AND MAINTENANCE THIS PRODUCT
IS ONLY SUITABLE FOR WELL INSULATED SPACES OR OCCASIONAL USE

SAFETY
Read the Installation and User Guide(*), especially the safety instructions below.
WARNING -Certain parts of this product
may become very hot and may cause
burns. Pay extra attention to small
children and vulnerable people when
they are around the heater.
This heater may be used by children aged 8 and over and by persons with
reduced physical, sensory or mental capacity or without any experience or
knowledge providing they are correctly supervised, or they have been given
instructions on how to use the heater safely and they clearly understand the
potential hazards. Children must not play with the heater unless supervised.
Children must not perform user cleaning and maintenance.
Ensure children aged under 3 are kept at a safe distance unless they are
under constant supervision.
Children aged between 3 and 8 may only turn the heater on or off providing it
has been placed or installed in the normal position for its operation and
providing they are under supervision, or they have been given instructions on
how to use the heater safely and clearly understand the potential hazards.
Children aged between 3 and 8 must not plug in, change the heater
settings, clean or perform any user maintenance on the heater.
Do not insert anything into the heater.
The heater may only be connected by a qualified person after the power has
been switched off.
.
Caution,
hot surface

GENERAL INFORMATION
We wish to thank you for purchasing a heater produced by our company. This document
is restricted in use to the terms of the law and may not be copied or transferred to third
parties without the express authorisation of the manufacturer.
Our heaters are subject to change and some parts may appear different from the ones
shown here, without this affecting the text of the manual in any way.
Read this manual carefully before performing any operation (installation, maintenance,
use) and follow the instructions contained in each chapter. Keep the manual carefully for
future reference. After removing the packaging, check that the appliance is in perfect
condition. The packaging materials must not be left within reach of children as they can
be dangerous.
THE MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGES TO PERSONS OR
PROPERTY CAUSED BY FAILURE TO FOLLOW THE INSTRUCTIONS IN THIS
MANUAL.
The manufacturer reserves the right to make any changes it deems advisable to its
models, although the essential features described in this manual remain the same.
During installation and maintenance, respect the precautions indicated in the manual,
and on the labels applied inside the units, as well as all the precautions suggested by
good sense and by the safety regulations in effect in your country.
This product is covered by a 2-year warranty
For more information please contact:
AUSTRALIA:
email: [e-mail], PH [phone]
www.olimpiasplendid.com.au
NEW ZEALAND:
email: [e-mail], PH [phone]
www.olimpiasplendid.co.nz
IMPORTANT SAFETY INFORMATION
1. Avoid installation behind a door.
2. Use only the voltage specified on the rating plate of the heater.
3. Do not cover or restrict airflow to the inlet or exhaust grilles in any manner as the
appliance may overheat and become a fire risk (for Fan Heaters).
4. Do not cover grilles, block entry or exhaust of airflow by placing appliance against
any surface. Keep all objects at least 1-metre from the front and sides of the
appliance. With the exception of appliances designed for wall-mounting, maintain
a 1 metre gap from the rear of the unit as well.
WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR
POSITIONED CLOSE TO CURTAINS OR OTHER COMBUSTIBLE
MATERIALS

5. Do not place appliance close to a radiant heat source.
6. Do not operate in areas where gasoline, paint or other flammable liquids are used
or stored.
7. This appliance heats up when in use. To avoid burns, do not let bare skin touch
hot surfaces. Switch off and use handles where provided when moving.
8. Do not use the appliance to dry clothes.
9. Do not leave the appliance unattended whilst in use.
10.Do not insert or allow foreign objects enter any ventilation or exhaust opening, as
this may cause an electric shock, fire or damage to the appliance.
11.Do not immerse in liquid or allow liquid to run into the interior of the appliance, as
this could create an electrical shock hazard.
12.Do not use this appliance on a wet surface, or where it can fall or be pushed into
water.
13.Do not reach for an appliance that has fallen into water. Switch off at supply and
unplug immediately.
14.Do not operate any appliance with a damaged cord, plug or after the appliance
malfunction or has been dropped or damaged in any manner. Return to a
qualified electrical person for examination, electrical or mechanical adjustment,
service or repair before further use.
15.Do not operate appliance with wet hands.
16.This appliance is intended for household use only and not for commercial or
industrial use.
17.Use this appliance only as described in this manual. Any other use is not
recommended by the manufacturer and may cause fire, electric shock or injury.
18.A common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and
vacuum-cleaning air vents and grilles, where available.
19.Do not use this appliance in a window as rain may cause electric shock.
20.Do not use abrasive cleaning products on this appliance. Clean with a damp cloth
(not wet) rinsed in hot soapy water only. Always unplug the unit before cleaning.
21.Do not connect the appliance to the mains source until it has been installed in its
final location and adjusted to the position it will be used in.
22.This appliance is not intended for use in bathrooms, laundry or similar locations
which may be exposed to water, moisture or humidity.
23.Always operate on a flat horizontal surface.
24.Switch off the appliance, then use handles (where provided) to change its
position.
25.Do not operate with the cord coiled up as this could cause a build up of heat,
which could pose a hazard.
26.Do not use an extension cord or power board with the appliance.
27.Do not remove the power plug from the socket by pulling the cord – grip the plug
instead.

28.Always unplug appliance when not in use.
29.Do not allow cord to come in contact with heated surfaces during operation.
30.Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away
from areas where it is likely to be tripped over.
31.Do not twist, kink or wrap the cord around the appliance, as this may cause the
insulation to weaken and split. Always ensure that the cord has been fully
removed from any cord storage area before use.
32.Do not store appliance in a box or closed space until it has cooled down
sufficiently.
33.This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
34.Young children should be supervised to ensure they do not play with the
appliance.
35.The appliance must not be located immediately below a socket-outlet.
36.Do not use this appliance with a programmer, timer or any other device that
switches the heater on automatically, since a fire risk exists if the appliance is
covered or positioned incorrectly.
37.If the supply cord is damaged, it must be replaced by a qualified electrical person
in order to avoid a hazard.
38.Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on
the appliance.
39.In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
40.For additional protection, the use of a Residual Current Device (RCD) with a
tripping current not exceeding 30mA is recommended.
Warning:Very hot surface Important: Do not cover

OVERVIEW
OPERATION
1. Before inserting the plug into an electrical outlet, make sure that the electrical
supply in your area matches that on the rating label on the unit.
2. When plugged in, turn on the Main power switch at the rear of the unit.
3. When in Standby mode, only ON/OFF on the control panel will respond to your
touch. Press ON/OFF to access the rest of the control panel.
CONTROL PANEL
a) Press switch to fan function, press again and the heater will turn off
automatically in 30 seconds.
b) Press to switch the power on. Press to switch to low power, press it again,
for high power, press it third time, to change to fan function.
c) Press again, the heater will turn off automatically in 30 seconds
d) TIMER: Press repeatedly to set a period after which the heater will turn itself
off (between 1 hour - 12 hours, in steps of 1 hour). During timer operation, the
remaining operating time is displayed, until the heater turns itself off. Pressing
the timer button once more after the display shows 00 hours will cancel the timer.

e) OSC: Press to activate oscillation. Press again to cancel.
f) While using, press ‘+’& ‘-‘ to control the temperature. When the room temperature
rises to the set temperature, the heater will stop heating. When room temperature
drops below set temperature, the heat will turn on again.
g) Regulate the temperature by pressing ‘+’ ‘-‘. Start-up again, first time press ‘+’ ‘-‘, the
temperature starts from room temperature (then change according to last
temperature setting), keeping between 35℃and 10℃. Each press changes by 1℃.
Pressing ‘+’ & ‘-‘, on the display will show the desired temperature setting, after
which the display will show the current room temperature.
h) Movable head (forward/backward): Set the unit to the desired angle to project the
heat. See below photo.
Warning: The heater will remain hot for some time after it is turned off; handle with care.
Remote control
Please use Lithium battery CR2025 3V.
NOTE: the remote control buttons perform the same functions as those on the control
panel on the unit.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance automatically
when the heater falls over or is at an excessive angle (horizontal). This helps prevent
accidents, and the heater will resume operation when it is put back upright.
If it is suspected the battery has
been swallowed or otherwise
placed inside any part of the
body, a person should contact
the Australian Poisons
Information Centre immediately
on 13 11 26 (in Australia) or
0800 764 766 (in New Zealand)
for fast, expert advice.

THERMAL CUT-OFF
This heater is protected with thermal cut-off protection that switches off the appliance
automatically in case of severe overheating. In this case, unplug the appliance, wait
about 30 minutes for it to cool and remove any possible cause of overheating, eg.
something covering the heater. Check for damage to the appliance, the cord and the
plug. If there is no damage, plug the unit back in and switch it on as described above. If
the heater still does not turn on, please contact Customer Service for assistance.
CLEANING & MAINTENANCE
•Before undertaking any cleaning or maintenance on the appliance, disconnect it
from the power supply.
•For cleaning it is recommended to use a soft moist rag and neutral detergent. Do
not use an abrasive cloth or devices which could affect the appearance of the
appliance. Check that the hot air outlet and the ventilation inlet are free of dust
and dirt. During cleaning, be careful not to touch the heating elements.
•In case of breakdown and/or poor functioning of the appliance, disconnect the
appliance from the power supply and contact an authorised repairer.
SPECIFICATIONS
Power Supply: AC 220-240V ~ 50Hz
Power Consumption: 2000W
Environment
Meaning of crossed-out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities. Contact your local council for information
regarding the collection systems available. If electrical appliances are
disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.